Craftsman 126.32563 Manual Del Operador página 31

MAKING A BASIC CUT
WARNING I
Ensure that the workpiece is securely
clamped to the saw table and against the
fence and in the required position, before
plugging the saw into a power source. Cut
only one piece at a time. Ensure that the
carriage slide is locked in its rear most
position with the carriage slide locking
screw securely tightened.
With the power OFF, lower the Cutting
Head towards the workpiece to observe
the path of the blade.
Also switch on the laser guide to preview
the path of the blade.
With the Cutting Head in its upper position,
squeeze the trigger switch to start the
motor.
Allow the motor and blade to run up to full
speed.
Gently but firmly lower the Cutting Head
to its lowest position cutting through the
workpiece.
Release the trigger switch and allow the
blade to come to a complete halt.
Raise the Cutting Head to its upper
position with the guard covering the blade,
before removing your hand from the
Cutting Head Handle.
Only remove the workpiece when the
Cutting Head is in the upper position with
the blade guard covering the blade and
the motor stopped.
IA WARNING I
Never leave the saw unattended and
plugged into a power source.
Make the workshop childproof, and always
lock the workshop when not in use.
Store the tool in a secure, locked cupboard
or similar with no access for unqualified
users or children.
MAKING A BASIC MITER CUT
Any angle from 45 oleft to 45 oright is available,
and a dual protractor scale can be found on the
front of the machine base.
Positive stops are located at 0°, 15°,
22.5°,31.60,450 to the right and to the left.
Loosen the Miter Handle Locking
Knob. This is situated to the front of the
Miter handle, and just above the Positive
Stop Locking Lever. (Fig. W)
(Fig. W_
31