Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION
First steps
•
Remove the unit from the packaging.
•
Remove the packaging materials from the unit.
•
Store the packaging materials in the packaging or dispose of them properly.
Before installation
•
After unpacking, check all components for completeness and only then
dispose of the packaging materials.
•
The packaging material contains small parts that must be kept at a safe
distance from small children.
•
Before installation, open the packaging containing small parts such as screws,
remove them all together and store them in a box so that the small parts do
not get lost before installation.
Important installation instructions
General precautions must be taken when using electrical equipment to reduce the
risk of fire, electric shock and injury. This includes the following:
•
First remove the glass.
•
Do not connect the appliance to the power supply until it has been properly
mounted on the wall and you have read the entire operating instructions.
•
Minimum distances must be respected.
•
When installing the unit, be careful not to damage concealed cables.
•
Take care when drilling the holes.
•
This unit is intended for permanent wall mounting at a minimum height of
300 mm. The wall bracket must be mounted horizontally and the cable must
be routed to the bottom right of the heater.
•
For an optimal view of the fuel bed, installation at a height of 600 mm above
the floor is recommended.
EN
23
Publicidad
