Publicidad
Idiomas disponibles
Idiomas disponibles
STEP 4
4.1)
Cut the tailpipe to the dimension determined in Figure 4.1.
4.2)
Install the sink drain components to the lid as shown in Figure 4.2.
4.3)
Orient the lid assembly as shown in Figure 4.3 and secure the trap components.
(HAND TIGHTEN the assembly to the lid at this time. Adjustment will be required in Step 5.)
Note: To ensure a proper water seal, the extension must be installed as shown in the "trap detail".
INTERNAL TRAP COMPONENTS SUPPLIED BY OTHERS.
X
TAILPIPE
LENGTH
4 1/2"
Figure 4.1
TAIL PIPE
DISCHARGE
Figure 4.3
Internal Trap Installation Only
DIMENSION MEASURED
IN STEP 1.
TRAP DISCHARGE PARTIALLY
VISIBLE THROUGH THE CORD
SEAL OPENING.
CORD SEAL OPENING
VENT
© Copyright 2023 Zoeller
TAIL PIPE
INLET
TRAP
Figure 4.2
Co. All rights reserved.
®
6
TRAP DETAIL
4"
FLANGED TAIL PIPE
(SEE NOTE)
SK2004
Publicidad
