HSM Pure 740 max Instrucciones De Servicio página 15

7 Cleaning and maintenance
WARNING
Dangerous mains voltage!
Improper handling of the machine can lead to an electric shock.
Switch off the document shredder before relocating or cleaning and disconnect
the power plug.
Service work which requires the housing covers to be removed may only be
carried out by HSM Customer Service and service technicians from
our contractual partners.
For our customer service addresses see page 164.
Clean the document shredder only with a soft cloth and a mild soap-water solution.
Do not allow water to enter the equipment when doing this.
Let the cutting unit run in permanent mode for about 10 seconds without any paper.

► This loosens paper dust and particles.
8 Disposal / recycling
Electrical and electronic old devices contain a variety of valuable materials, but also
hazardous substances which were required for functionality and safety. Incorrect
disposal or handling can be dangerous to your health and the environment.
Never dispose of old devices in the residual waste. Observe the current applicable
regulations and use the collection points for returning and recycling electric and
electronic devices. Also dispose of the packaging material in an environmentally-
responsible way.
11/2020
Only in the event of particle cutting: Oil the cutting unit when cutting
performance decreases or the device becomes noisy, or every
time you empty the waste container. Only use special cutting head
lubricating oil to do this:
Spray the special cutting unit oil through the paper feed along

the entire width of the cutting shafts.
PURE 740 max
english
15