Peg-Perego VIAGGIO TWIST Instrucciones De Uso página 20

c) Harness tension release button
d) Adjustment of belt tightness
e) Knob for adjusting inclination
f ) Full 5-point safety harness with shoulder pads
g) Belt clip
h) Lever for release from base
i) Headrest height adjustment button
l) Instruction manual compartment.
m) Headrest covered with shock-absorbing
expanded polystyrene (EPS)
n) Kinetic Pods: side protections
The car seat is ready for use: no assembly required.
Instructions for use with base
1 Attach Viaggio Twist by positioning it on the
Base Twist near the connectors (check the base
shape matches) and pushing downwards until it
clicks.
Make sure that the red/green indicators on
the side of the rotating plate are in the green
position.
IMPORTANT: after completing the operation,
try moving the car seat to verify that the
Isofix fittings have been connected correctly.
2 To detach Viaggio Twist from the Base Twist, pull
the lever that is in the front and under the seat
and, at the same time, lift the seat.
3 To adjust the car seat's inclination, rotate the
knob until the seat is in the desired position.
4 The headrest must be adjusted to match the
child's height. There are several positions.
To switch from a low to a higher position: pull
the tongue at the centre of the head rest (1)
upward; the head rest simultaneously lifts (2).
To switch from a high position to a lower one:
pull the lever in the upper central part of the
headrest upwards and, at the same time, push
the headrest down to the desired position.
When you have finished, slightly move the
headrest to check it is properly locked into place.
5 To guarantee greater safety, the car seat is
equipped with Kinetic Pods. Open the Kinetic Pod
on the side near the car door (fig_a). To close it, pull
the Kinetic Pod and fold it down into the specific
hollow (fig_b).
6 Viaggio Twist uses a 5-point harness to protect
your child. Before placing the child on the seat.
Act on the central release button and pull the
straps, loosening the belts (fig_a). Do not pull
the shoulder pads.
Open the chest clip following the procedure
shown (fig_b), unfasten the safety belts by
acting on the red button of the crotch strap's
buckle (fig_c).
7 Attach the buckles to the side elastics and pull
the crotch strap towards the front of the seat to
make room for the child. Make sure the sitting
area is free.
8 RF CAR SEAT (a): Place the child in the car
seat and arrange the harness over the child's
20