DeWalt DCCS674 Manual De Instrucciones página 20

English
Repairs
The charger and batteries are not serviceable. There are no
serviceable parts inside the charger or battery pack.

WARNING: To assure product SAFETY and RELIABILITY,
repairs, maintenance and adjustment (including
brush inspection and replacement, when applicable)
should be performed by a factory service center or
an authorized service center. Always use identical
replacement parts.
Register Online
Thank you for your purchase. Register your product now for:
• WARRAnTY sERViCE: Registering your product will
help you obtain more efficient warranty service in case
there is a problem with your product.
• COnFiRMATiOn OF OWnERshiP: In case of an
insurance loss, such as fire, flood or theft, your registration
of ownership will serve as your proof of purchase.
• FOR YOUR sAFETY: Registering your product will allow
us to contact you in the unlikely event a safety notification
is required under the Federal Consumer Safety Act.
• Register online at www.dewalt.com.
Two Year Commercial Warranty
For warranty terms, go to https://www.dewalt.com/
support/warranty.
To request a written copy of the warranty terms, contact:
Customer Service at D WALT Industrial Tool Co., 701 East
e
Joppa Road, Towson, MD 21286 or call 1-800-4-D
(1-800-433-9258).
lATin AMERiCA: This warranty does not apply to products
sold in Latin America. For products sold in Latin America,
see country‑specific warranty information contained in
the packaging, call the local company or see website for
warranty information.
FREE WARning lABEl REPlACEMEnT: If your warning
labels become illegible or are missing, call 1-800-4-D
(1-800-433-9258) for a free replacement.
18
DCCS674 TROUBLESHOOTING
Problem
Unit will not start.
Unit shuts down
in use.
Battery
won't charge.
WALT
e
Bar /
Chain overheated.
Chain is loose.
Poor cut quality.
WALT
e
Unit runs but does
not cut.
Unit does not oil.
Solution
Check battery installation.
Check battery charging requirements.
Press the On/Off button before squeezing the lock
off lever and trigger switch.
Check that chain brake is disengaged.
Disengage the chain brake/front hand guard. Pull
the chain brake/front hand guard towards the
front handle into the "set" position as shown in
Fig. O. Restart the unit.
Check that lock off lever is fully pushed forward
prior to moving trigger switch.
Charge battery.
Unit is being forced. Restart and apply less pressure.
Insert battery into charger until red charging light
illuminates. Charge up to 8 hours if battery is
totally drained.
Plug charger into a working outlet. Refer
to Important Charging Notes for
more details.
Check current at receptacle by plugging in a
different appliance.
Check to see if receptacle is connected to a light
switch which turns power off when you turn out
the lights.
Move charger and appliance to a surrounding air
temperature of above 40 °F (4.5 °C) or below
104 °F (40.5 °C).
Refer to Adjusting Chain Tension section.
Refer to Chain Oiling section.
Refer to Adjusting Chain Tension section.
Refer to Adjusting Chain Tension section.
NOTE: Excessive tension leads to excessive wear
and reduction in life of bar and chain. Lubricate
before each cut. Refer to Replacing the Saw
Chain section.
Chain could be installed backwards. Refer to sections for
Installing and Removing Chain.
Refill oil reservoir.
Clean guide bar, sprocket and sprocket cover. Refer
to Care And Maintenance section.