Craftsman 919.167342 Manual De Instrucciones página 15

4. Move the On/Auto/Off lever
to "On/Auto" position. The
compressor wilI start,
5. Run the compressor for 15
minutes. Make sure the drain
valve is open and there is
minimal air pressure build-up in
tank,
6. After 15 minutes, close the drain
valve (clockwise). The air receiver
wilI fill to "cut-out" pressure and
the motor wilI stop,
The compressor is now ready for use.
Before Each Start-Up:
1. Place On/Auto/Off lever to "Off".
2. PulI regulator knob out, turn
counter-clockwise until it stops.
Push knob in to lock in place,
3. Attach hose and accessories.
NOTE: The hose or accessory
wilI require a quick connect ptug
if the air outlet is equipped with a
quick connect.
Too much air
pressure causes a
hazardous risk of bursting, Oheck
the manufacturer's maximum
pressure rating for air tools and
accessories, The regulator outmet
pressure must never exceed the
maximum pressure rating,
How to Start:
1. Turn the On/Auto/Off lever
to "On/Auto" and allow tank
pressure to build. Motor will
stop when tank pressure reaches
"cut-out" pressure,
2. PulI the regulator knob out and
turn clockwise to increase
pressure. When the desired
pressure is reached push knob in
to Iock in place. The compressor
is ready for use.
NOTE: Always operate the air
compressor in wetI-ventilated areas
free of gasoline or other combustible
vapors. Ufthe compressor is being
used to operate a sprayer DO NOT
place near the spray area.
15-ENG A09708