Publicidad
Idiomas disponibles
Idiomas disponibles
− If the leak persists or comes from a different part, stop using your plancha and
contact your dealer.
Never use an appliance that leaks gas.
CHANGING THE GAS CYLINDER
Always turn off the control knobs and gas cylinder valve before changing the gas
cylinder.
Change the gas cylinder in a well-ventilated location away from any heat source
(cigarettes, electrical appliance, etc.).
Whenever you change the gas cylinder, perform a leak-tightness test.
Use
SWITCHING ON
− The appliance is ready for use.
− Open the valve on the gas cylinder.
− Open the plancha valve by turning the knob to the high flame position (image on
the ring around the knob).
− Once in this position, push in the knob and press the igniter switch to light the
burner. Check that the burner is completely lit by looking through the openings
on the side of the appliance.
− Keep the knob pressed in for 5 - 10 seconds to engage the thermocouple safety
system (see Figure 5).
− Then release the knob and wait for the burner to heat the cooking plate to the
required temperature.
− Preheat the plancha by setting the control knob to the high flame position for 5
to 10 minutes, then turn it to the low flame position.
− Your appliance is ready for use.
NOTES
The first time you use your plancha, you may notice some smoke and an odour from the
appliance. This is normal.
- 24 -
Publicidad
