cecotec bolero DRESSCODE 740 BI Inverter A Manual De Instrucciones página 76

ENGLISH
Box content
Washing machine
-
Hose
-
Instruction manual
-
Caps
-
3. INSTALLATION
- Place the device on a flat, stable and dry surface. Make sure the product does not stand
on the power cord. F
- Be sure to maintain minimum clearances to walls. Fig. 3
- Avoid exposure to direct sunlight and heat sources. Ensure good ventilation.
Remove the cardboard box and Styrofoam packing.
-
Lift the washing machine and remove the base packing. Make sure the small triangle
-
foam is removed with the bottom one together. If not, lay the unit down with on the side
surface, then remove the small foam from the unit bottom manually. Fig. 4
Remove the tape securing the power supply cord and drain hose.
-
Remove the water supply hose from the drum.
-
Removing the transport bolts
The transport bolts must be removed from the backside of the device before using it.
-
The transport screws will be necessary again when moving the product, so make sure
-
they are kept in a safe place.
This appliance is heavy. Transport it with care. Do not hold any protruding parts when
-
lifting. Do not use the door to lift the appliance.
In order to remove the bolts
Fig. 5
Loosen the 4 bolts with a spanner and then remove them.
-
Stop the holes with transport hole plugs.
-
Keep the transport screws properly for future use.
-
Levelling the washing machine. Fig. 6
Warning
The lock nuts on all four feet must be screwed tightly against the housing.
Check if the legs are closely attached to the cabinet. If not, please turn them to their
-
original position and tighten the nuts.
Loosen the lock nut to turn the feet until they are in contact with the floor.
-
Adjust the feet and tighten the washers with a spanner. Make sure the machine is steady.
-
76
BOLERO DRESSCODE 740/840/940 BI INVERTER A