cecotec bolero DRESSCODE 740 BI Inverter A Manual De Instrucciones página 92

ENGLISH
Mute Mode
Switch on the equipment
-
Select a programme
-
Press the Start/Pause button
-
Press and hold the Temp button for approx. 3 seconds. No beeps shall be heard.
-
To reactivate the sound, press the Temp button again for about 3 seconds.
-
Note: the setting will be saved until next restart.
-
Usage counter
Unplug the equipment for 10 seconds and plug it in again.
-
Switch on the machine and wait for 10 seconds, press
-
simultaneously and continuously for about 5 seconds until the display shows digits. The
value indicates the usage times of the machine.
Repeat step 1 again to resume normal operation.
-
Tips for use
After a programme is completed, wait for two minutes before opening the door.
-
Check whether the water inside the drum has been drained before opening its door. Do
-
not open the door if there is any water.
Do not wash only one piece of clothes or garment, as these could cause great unbalance.
-
Always introduce at least 3 or 4 clothes so that draining can be done smoothly.
The information given for the programmes different to the eco 40-60 programme are just
-
indicative.
The eco 40-60 programme can clean normally soiled cotton clothes declared as
-
washable at 40ºC or 60ºC, together in the same cycle. This programme is used to assess
compliance with EU eco-design legislation.
The times indicated for each programme match the length with standard loads and
-
temperatures. Other loads and temperatures will need different programme length.
The most efficient programmes in terms of energy consumption are generally those that
-
are carried out at lower temperatures and longer length.
Load the washing machine to the quantity estimated for each programme, this will help
-
you save energy and water.
The length, and energy and water consumption of each programme may vary according
-
to the weight and type of laundry, the additional functions active, water, and ambient
temperature.
It is recommended the use of liquid detergent for washing programmes at low
-
temperature. You can vary the quantity of detergent according to the quantity of laundry
and its soiling level. Follow the detergent manufacturer recommendations for the
quantity of detergent you must use.
You can find more information on this model by scanning the QR code of the reference of
-
your product (you will also find the energy label).
92
BOLERO DRESSCODE 740/840/940 BI INVERTER A
and on the control panel