cecotec DRUMFIT WAYHOME 1500 SPRINT Manual De Instrucciones página 63

Before moving the treadmill, make sure that the power switch is in the OFF position and the
power cord is unplugged from the power outlet.
Folded Fig. 12
Remove the retaining pin and lift the platform off the ground to fold the machine. Then screw
the pin back in until the belt is securely fastened.
Unfolded Fig. 13
Remove the retaining pin and press the piston lightly with your foot. Slowly lower the belt
frame to the ground. Then screw the pin back in until the belt is securely fastened. Turn on the
switch to start using the machine.
Carrying
The treadmill has wheels to facilitate transport. Before moving the treadmill, make sure that
the power switch is in the OFF position and the power cord is unplugged from the power outlet.
NOTE: only use lubricants made from silicone oil. Do not apply any other type of oil, otherwise
the belt may deteriorate. Do not over-lubricate the platform.
Wipe off excess lubricant with a clean cloth.
Walking belt lubrication Fig. 14
- The treadmill is already lubricated with silicone oil. This oil is non-volatile and is spread
over the entire surface of the board. Under normal circumstances, it is not necessary to
lubricate the walking belt.
- However, there is an extra bottle of silicone oil for belt maintenance. You can reapply a
little lubricant when you notice that the belt resists and starts to rub against the board.
Make sure that the lubricant reaches the centre of the platform. Allow the oil to "settle" for
a few minutes before using the belt again.
NOTE: only use silicone oils for this machine. Do not over grease the belt.
Excess oil should be removed with a clean cloth.
DRUMFIT WAYHOME 1500 SPRINT
ENGLISH
63