Waeco ASC 6300 G Instrucciones De Uso página 14

EN
PAR
Loud
Quiet
ENTER‐OK
7. Use the cursor keys or to select the desired volume.
8. Press ENTER
9. Press STOP
The volume chosen is active and the standby menu is displayed.
12.7 Entering the company data
The company data is printed out with every service log.
1. In the basic menu use the cursor keys or to select Other selections.
Short selection
Free selection
Other selections
ENTER‐OK
2. Press ENTER
3. Use the cursor key to select Service.
4. Press ENTER
5. Enter the password
The company data is shown in the third line of the display.
You can enter five lines, each with up to 20 characters.
The display shows the number of lines of company data after the message Enter company data (01 to 05).
Use the cursor keys or to select the line of company data you want.
6. Use the keypad and the cursor keys to enter the data. To switch between upper and lower case, press the
key. To delete a character, briefly press the
key.
7. Press ENTER
8. Press STOP
The set data is activated.
9. Press STOP
The standby menu is displayed.
12.8 Entering the date and time
Date and time are required for logging of the service procedures. The date and the time are printed along with the
company data on every service log.
1. In the basic menu use the cursor keys or to select Other selections.
Short selection
Free selection
Other selections
ENTER‐OK
2. Press ENTER
3. Use the cursor key to select Service.
4. Press ENTER
5. Enter the password
6. Use the keypad and the cursor keys to enter the information.
7. Press ENTER
14
to confirm.
.
to confirm.
to confirm.
.
3282
to confirm.
.
again.
to confirm.
to confirm.
.
8463
to confirm.
Buzzer
C key. To delete the current line, press and hold down the C