Sony YY7862E Guía De Referencia

Wireless Speaker
Reference Guide Guía de referencia
Model, Modelo: YY7862E
https://rd1.sony.net/help/
speaker/7862/h_zz/
5-057-416-61(1)
©2024 Sony Corporation
Printed in China
https://www.sony.net/
English Wireless Speaker
Model: YY7862E
The term "product" in this document refers to the unit or its accessories.
CAUTION: To avoid deterioration of the water-resistant performance,
make sure that the cap is closed completely when using the unit.
The nameplate and important information concerning safety are
attached in the following locations:
• the inner surface of the cap on the rear side of the unit
Do not install the product in a confined space, such as a bookcase or
built-in cabinet.
Do not expose the batteries (battery pack or batteries installed) to
excessive heat, such as sunshine, fire or the like, for a long time.
Do not subject the batteries to extreme low temperature conditions that
may result in overheating and thermal runaway.
Do not dismantle, open, or shred secondary batteries.
In the event of a secondary battery leaking, do not allow the liquid to
come in contact with the skin or eyes. If contact has been made, wash
the affected area with copious amounts of water and seek medical
advice.
Secondary batteries need to be charged before use. Always refer to
the manufacturer's instructions or product manual for proper charging
instructions.
After extended periods of storage, it may be necessary to charge and
discharge the secondary batteries several times to obtain maximum
performance.
Dispose of properly.
Do not expose the unit to naked flame sources (for example, lighted
candles).
This product has magnet(s) which may interfere with pacemakers,
programmable shunt valves for hydrocephalus treatment, or other
medical devices. Do not place this product close to persons who use
such medical devices. Consult your doctor before using this product if
you use any such medical device.
Never insert the USB plug when the main unit or charging cable is wet.
If the USB plug is inserted while the main unit or charging cable is wet,
a short circuit may occur due to liquid (tap water, seawater, soft drink,
etc.) or foreign matter on the main unit or charging cable, and cause
abnormal heat generation or malfunction.
Licenses
• This product contains software that Sony uses under a licensing
agreement with the owner of its copyright. We are obligated to
announce the contents of the agreement to customers under
requirement by the owner of copyright for the software. Please
access the following URL and read the contents of the license.
https://rd1.sony.net/help/speaker/sl/24/
• This product is protected by certain intellectual property rights
of Microsoft Corporation. Use or distribution of such technology
outside of this product is prohibited without a license from
Microsoft or an authorized Microsoft subsidiary.
• Services offered by third parties may be changed, suspended,
or terminated without prior notice. Sony does not bear any
responsibility in these sorts of situations.
Notes on waterproof and
dustproof features
(Read before using the unit)
The supplied accessories are neither waterproof nor
dustproof.
On waterproof and dustproof performance
of the unit
The unit, with the cap fastened securely, has a waterproof specification
of IPX7 as specified in "Degree of protection against water immersion"
of the IEC60529 "Ingress Protection Rating (IP Code)", and a dustproof
specification of IP6X as specified in "Degrees of protection against solid
foreign objects".
• The supplied accessories and the connectors of this unit (USB) are
neither waterproof nor dustproof. To reduce the risk of fires or electric
shocks, do not expose the unit to water or droplets while using any
connectors (USB) .
Note that malfunctions as a result of water immersion or dust
intrusion caused by misuse by the customer are not covered by the
warranty.
To maintain waterproof and dustproof
performance
Carefully note the precautions below to ensure proper use of the unit.
• The unit passes the drop test from 1.22 m on plywood of 5 cm
thickness conforming to MIL-STD810H Method 516.8-Shock. However,
this does not guarantee no damage, no breakdown, or waterproof
and dustproof performance in all conditions. Deformation or damage
from dropping the unit or subjecting it to mechanical shock may cause
deterioration of the waterproof and dustproof performance.
• This unit does not have a design that is resistant to water pressure.
Use of the unit in a location where high water pressure is applied, such
as in the shower, may cause a malfunction.
• Do not pour high-temperature water or blow hot air from a hair dryer
or any other appliance on the unit directly. Also never use the unit
in a place subject to high temperatures, such as in a sauna or near a
heat source.
CAUTION : Handle the cap with care. The cap plays a very
important role in maintenance of the waterproof and dustproof
performance. When using the unit, make sure that the cap is closed
completely. When closing the cap, be careful not to allow foreign objects
inside. If the cap is not closed completely the waterproof and dustproof
performance may deteriorate and may cause a malfunction of the unit
as a result of water or dust particles entering the unit.
Passive radiator
Precautions
On placement
• To eliminate the risk of malfunctions, avoid the following locations
when placing or leaving this unit.
– A place subject to high temperatures, such as under direct sunlight
or lighting equipment, near a heat source, or in a sauna
– Inside a vehicle with the windows closed (especially in
summertime)
– A place exposed to hot air, such as from a hair dryer
• Place this unit on a flat, level surface. When placed on a sloped
surface, the unit may fall over or fall off the surface due to its
own vibration, resulting in injuries, malfunctions, or performance
degradation.
• This unit is not anti-magnetic. Keep objects susceptible to magnetism
(recorded tapes, watches, cash cards and credit cards with magnetic
coding, etc.) away from the unit. When you carry around the unit, keep
this in mind as well.
How to care for the unit
Although the fabric part of the unit has water repellent treatment
applied, you can use the unit more comfortably and for a longer period
of time by following the maintenance procedure below.
• If the surface of the unit gets dirty in the following cases, wash the
unit with fresh water (tap water, etc.) promptly to remove the dirt.
Leaving dirt on its surface may cause the fabric part or the passive
radiator section to discolor or deteriorate, or the unit to malfunction.
Ex.
– When salt, sand, etc. is stuck on the unit after using it on a beach,
pool side, etc.
– When the unit is stained with sweat or foreign substances
(sunscreen, suntan oil, etc.)
Note
• If the surface of the unit gets dirty, do not use detergent, thinner,
benzine, alcohol, etc. to clean the unit because it will affect the water
repellent function of the fabric part of the unit.
• If sand grains, etc. enter the fabric or other part of the unit, remove
them carefully. Never use a vacuum cleaner, etc. on the unit. It may
cause damage of the speaker section or other part of the unit.
Other notes
• Do not use or leave the unit in an extremely cold or hot environment
(temperature outside the range of 5 °C - 35 °C). If the unit is used or
left in outside the above range, the unit may automatically stop to
protect internal circuitry.
• Even if you do not intend to use the unit for a long time, charge
the battery to its full capacity once every 6 months to maintain its
performance.
• If you have any questions or problems concerning this unit that are
not covered in this manual, please consult your nearest Sony dealer.
Trademarks
• Microsoft and Windows are registered trademarks or trademarks of
Microsoft Corporation in the United States and/or other countries.
• The BLUETOOTH® word mark and logos are registered trademarks
owned by Bluetooth SIG, Inc. and any use of such marks by
Sony Group Corporation and its subsidiaries is under license.
• USB Type-C® and USB-C® are registered trademarks of
USB Implementers Forum.
All other trademarks and registered trademarks are trademarks or
registered trademarks of their respective holders. In this manual, ™ and
® marks are not specified.
Specifications
BLUETOOTH®
Frequency band
2.4 GHz band (2.400 0 GHz - 2.483 5 GHz)
General
Power
DC 5 V 3 A (using a commercially-available USB AC adaptor capable
of feeding in 3.0 A) or, using built-in lithium-ion battery
Lithium-ion battery life
Approx. 12 hours* 2
– Volume level: 25
– Sound: ULT on
Approx. 3 hours* 2
– Volume level: 50 (MAX.)
– Sound: ULT on
Time required for charging the built-in rechargeable battery
Approx. 5 hours* 1 * 3
Operating temperatures
5 °C - 35 °C
Dimensions (including projecting parts and controls)
Approx. 206 mm × 77 mm × 76 mm (w/h/d)
Mass (including battery)
Approx. 650 g
Included items
Wireless Speaker (1)
USB Type-C® cable (USB-A to USB-C® / Max. 1.5 A)*
Strap (1) (attached to the unit)
Documents (1 set)
* 1 When connected to a USB AC adaptor that can supply an output
current of 1.5 A
* 2 The built-in battery life above is measured using our specified music
source. Actual performance time may vary from the listed time due
to the volume, songs played, surrounding temperature, and usage
conditions.
* 3 Time required for the empty battery to be fully charged (100%) while
the unit is powered off.
* 4 A charging cable exclusively designed for the unit. Do not use the
cable for any other purposes.
System requirements for charging battery using USB
Using a commercially-available USB AC adaptor capable of delivering an
output current of 1.5 A or 3.0 A*
(Use of a USB AC adaptor capable of delivering an output current of
3.0 A reduces the battery charging time.)
* When using a USB AC adaptor with an output current of 3.0 A, be sure
to use a USB Type-C cable that conforms to the USB standard and
supports an output current of 3.0 A.
The supplied USB cable supports an output current of up to 1.5 A.
Design and specifications are subject to change without notice.
Español Altavoz inalámbrico
Cap
Modelo: YY7862E
El término "producto" en este documento se refiere a
la unidad o sus accesorios.
POR FAVOR LEA DETALLADAMENTE ESTE MANUAL
DE INSTRUCCIONES ANTES DE CONECTAR Y OPERAR
ESTE EQUIPO.
RECUERDE QUE UN MAL USO DE SU APARATO
PODRÍA ANULAR LA GARANTÍA.
PRECAUCIÓN: Para evitar un rendimiento deficiente
de la protección contra el agua, asegúrese de que la
tapa esté completamente cerrada cuando utilice la
unidad.
Encontrará la placa de identificación e información
importante sobre seguridad en:
• la superficie interior de la tapa de la parte trasera
de la unidad
No instale el producto en un espacio reducido, como
una estantería o un armario empotrado.
No exponga las baterías (paquete de baterías o
baterías instaladas) a un calor excesivo, como la
luz del sol, el fuego o similares durante un periodo
prolongado.
No someta las baterías a condiciones de temperatura
extremadamente bajas, ya que podría producirse
sobrecalentamiento y fuga térmica.
No desmonte, abra ni corte las baterías secundarias.
En caso de fuga de una batería secundaria, no deje
que el líquido entre en contacto con la piel o los ojos.
Si se ha producido contacto, lave la zona afectada
con abundante agua y busque asistencia médica.
Hay que cargar las baterías secundarias antes de
utilizarlas. Consulte siempre las instrucciones del
fabricante o el manual del producto para conocer las
instrucciones de carga adecuadas.
Después de periodos prolongados de
almacenamiento, es posible que se deba cargar y
descargar las baterías secundarias varias veces a fin
de alcanzar su rendimiento máximo.
Deséchelas correctamente.
No exponga la unidad a fuentes de llama viva (por
ejemplo, velas encendidas).
AVISO IMPORTANTE PARA MÉXICO
La operación de este equipo está sujeta a las
siguientes dos condiciones: (1) es posible que
este equipo o dispositivo no cause interferencia
perjudicial y (2) este equipo o dispositivo debe
aceptar cualquier interferencia, incluyendo la que
pueda causar su operación no deseada.
Para consultar la información relacionada al número
del certificado, refiérase a la etiqueta del empaque
y/o del producto.
YY7862E LA (EN/ES) 5-057-416-61(1)
4 (1)