HIKOKI C1805DA Instrucciones De Manejo página 14

English
Always wear hearing protection.
Only for EU countries
Do not dispose of electric tools together with
household waste material!
In observance of European Directive
2012/19/EU on waste electrical and electronic
equipment and its implementation in
accordance with national law, electric tools that
have reached the end of their life must be
collected separately and returned to an
environmentally compatible recycling facility.
V
Rated voltage
n
0
No-load speed
Switching ON
0
Switching OFF
Disconnect the battery
Warning
Prohibited action
Mode selector switch
Lighting mode switch
Power mode is selected
Silent mode is selected
Always ON (turn off after 2 minute)
Light only SW-ON
Always OFF
Battery
Lights ;
The battery remaining power is over 75%.
Lights ;
The battery remaining power is 50%–75%.
Lights ;
The battery remaining power is 25%–50%.
Lights ;
The battery remaining power is less than 25%.
Blinks ;
The battery remaining power is nearly empty.
Recharge the battery soonest possible.
Blinks ;
Output suspended due to high temperature.
Remove the battery from the tool and allow it to
fully cool down.
Blinks ;
Output suspended due to failure or malfunction.
The problem may be the battery so please
contact your dealer.
NOTE
To prevent the battery power consumption caused by
forgetting to turn off the LED light, the light goes off
automatically in about 2 minutes.
STANDARD ACCESSORIES
In addition to the main unit (1 unit), the package contains
the accessories listed on page 263.
Standard accessories are subject to change without notice.
APPLICATIONS
Cutting various types of wood.
SPECIFICATIONS
1. Power tool
Model
Voltage
No-load speed
Cutting
Capacity
depth
Weight* 1
*1 According to EPTA-Procedure 01/2014
NOTE
Due to HiKOKI's continuing program of research and
development, the specifications herein are subject to
change without prior notice.
Electronic control
○ Soft-start
○ Overload protection
This protection feature cuts off the power to the motor in
the event of overloading of motor or a conspicuous
reduction in rotational speed during operation.
When the overload protection feature has been
activated, the motor may stop.
In this case, release the tool switch and eliminate
causes of overloading.
After that you can use it again.
○ Overheat protection
This protection feature cuts off the power to the motor
and stops the power tool in the event of overheating of
motor during operation.
When the overheat protection feature has been
activated, the motor may stop.
14
C1805DA
18 V
6000 min- 1 (Power mode)
3000 min- 1 (Silent mode)
90° 47 mm
45° 30 mm
2.6 kg (BSL1850MA)
3.0 kg (BSL36B18X)