HIKOKI C1805DA Instrucciones De Manejo página 19

Symptom
Cannot reverse incline
Parallelism cannot be fine tuned
Doesn't cut well
Switch can't be pulled
Sawdust discharge is poor
Possible cause
The incline lever (front) and incline
wing nut (rear) are not loosened.
The M5 hexagon socket set screw
holding the gear cover hinge needs to
be loosened.
The saw blade is worn or missing
teeth.
The bolt is loose.
The saw blade is installed
backwards.
The switch lock is not pushed in
enough.
Sawdust has accumulated in the saw
cover.
19
Remedy
Try inclining after loosening the
incline lever (front) and incline wing
nut (rear).
Loosen the M5 hexagon socket set
screw holding the gear cover hinge.
Replace with a new saw blade.
Firmly tighten the bolt.
Install the saw blade in the proper
direction.
Push the switch lock in all the way.
Remove the sawdust inside the saw
cover.
English