Care And Cleaning - Vitamix EXPLORIAN Serie Manual Del Usuario

TO SANITIZE THE CONTAINER WITH BLEACH:
1. Follow the cleaning instructions above.
2. Fill the container half full with water and 1-1/2
teaspoons of liquid bleach.
3. Snap or push the complete 2-part lid into the
locked position.
4. Rotate the dial clockwise to Variable Speed 1.
5. Press the Start/Stop Switch. Slowly increase the
variable speed to 10.
6. Run the appliance for 30 to 60 seconds.
7. Rotate the Variable Speed Dial back to Variable
Speed 1. Press the Start/Stop Switch.
8. Allow the mixture to stand in the container for
an additional 1-1/2 minutes.
9. Pour bleach mixture out. Allow container to air
dry. Do not rinse after sanitizing.
LIDS, LID PLUG, CENTERING PAD, AND TAMPER
All parts listed above are dishwasher safe.
If preferred, wash the parts in warm soapy water.
Rinse clean under running water, then dry.
BLENDER BASE
1. Turn off and unplug the blender.
2. Wash the outside surface with a damp, soft cloth or sponge that has been rinsed in a mild solution of liquid
dish soap and warm water. Do not place the blender base in water. The centering pad can be removed for more
thorough cleaning. The centering pad is dishwasher safe.
3. Immediately dry all surfaces and polish with a soft cloth.
129695
C
are and
WARNING
To Avoid Injury and Damage
To avoid inadvertent activation, turn off and unplug the blender before
cleaning.
Electrical Shock Hazard
ALWAYS unplug before cleaning the blender base or when not in use.
NEVER put the blender base in water or other liquid.
Failure to follow instructions can cause death or electrical shock.
C
leaning
TO SANITIZE THE CONTAINER WITH VINEGAR:
1. Follow the cleaning instructions above.
2. Prepare the vinegar solution: For the 2.0 L (64 oz.)
container, dilute 473 ml (16 oz.) of vinegar in 473 ml
(16 oz.) water.
3. Snap or push the complete 2-part lid into the
locked position.
4. Begin with Variable Speed 1 on the display. Press
the Start/Stop Switch.
5. Slowly increase the variable speed to 10.
6. Run the appliance on Variable Speed 10 for 2 full
minutes.
7. Rotate the Variable Speed Dial back to Variable
Speed 1. Press the Start/Stop Switch.
8. Allow mixture to stand in the container for an
additional 3 full minutes. Total contact time of the
vinegar solution in the container should equal 5
minutes.
9. Pour the vinegar solution out of the container over
the inside surface of the 2-part lid.
10. Repeat the sanitization procedure a second time
(Steps 2-9).
11. Allow the container and lid to air dry. Do not rinse
after sanitizing. If necessary, rinse immediately
before next use.
9