SUHNER ABRASIVE FH 9-INOX Documentación Técnica página 17

ty seconds. Vibrating tools must be replaced immediately.
2.2 r
Ating dAtA
Connection
Maximum speed
Maximum collet chuck
Weight
Vibration EN 60745
Max. wheel diameter
The specified vibration value was measured with a
standardised test method and may differ from the
actual operating value. The specified value can be
used for product comparisons or for an introductory as-
sessment of work breaks.
2.3 O
perAting cOnditiOns
Temperature range during operation: 0 to +50°C
Relative air humidity: 95% at +10°C not condensed
3. h
aNDLINg
3.1 w
Orking instructiOns
To achieve an optimum grinding result, move grinding
tool uniformly back and forth with light pressure.
Excessive pressure lessens the working capability of the
hand tool, as well as the life of the grinding tool.
3.2 s On/Off
witching
Hold the hand tool firmly. Switch on the drive.
Conduct the test run without load for at least thirty
seconds. Do not use vibrating grinding tools.
You must always hold the hand tool when it is op-
erating.
Switch off the drive when you stop working.
The tool still needs time to stop after the tool has been
switched off.
Put down the hand tool so that there can be no danger.
Remove the hand tool from the shaft.
4. S
ERvICE
4.1 p
reVentiVe mAintenAnce
Always keep the hand tool clean and in a dry
place.
Worn chucks must be replaced.
4.2 r
epAir
If despite strict observance of the manufacturing and test-
ing method the hand tool should happen to fail, it must be
repaired by an authorized SUHNER agency.
4.3 w
G28
-1
18'000min In the event of the tool being improperly handled, used
Ø 6mm / 1/4" for purposes for which it is not intended and/or of the ser-
0.560kg vice and maintenance instructions not being observed by
2 2
6.5m/s , K=1.8m/s non-authorized persons, no warranty shall be in effect for
55mm damages/consequential damages.
Complaints can only be honored if the hand tool is re-
turned in the undisassembled condition.
4.4 s
Temperature range during operation: -15°C to +50°C
Max. relative air humidity: 90% at +30°C, 65% at +50°C.
4.5 d
This hand tool consists of materials which can be dis-
posed of in a recycling process.
Before disposal, render the hand tool unusable.
/o
PERaTIoN
must be disposed of in an environmentally-compatible
recycling process.
/m
aINTENaNCE
ArrAnty
tOrAge
/ e
ispOsAl nVirOnmentAl cOmpAtiBility
Do not throw the hand tool into the garbage collec-
tion.
According to national regulations this hand tool
17