Aiwa JAX-N3 Instrucciones De Manejo página 9

ECO mode
Saves the power consumption while the unit is turned off (in
standby mode).
1 Press MODE repeatedly until "ECO MODE?"
appears in the display and then press ENTER.
2 Turn MULTI JOG to select "ECO ON" and then
press ENTER.
In the ECO ON mode, the unit blacks out when the unit is
turned off. Only the red indicator on POWER button lights
up.
If there is no MULTI JOG or button operation within 6
seconds, the setting is canceled.
To cancel the ECO mode
Repeat the above and select "ECO OFF" in step 2.
Dimmer
Adjusts the brightness of the display.
1 Press MODE repeatedly until "DIMMER ?"
appears in the display when the unit is turned on
and then press ENTER.
2 Turn MULTI JOG to select one of the three dimmer
modes or "OFF" and then press ENTER.
"OFF" is the brightest and "DIMMER 3" is the dimmest.
In DIMMER 3 mode, the spectrum analyzer display does
not appear.
If there is no MULTI JOG or button operation within 6
seconds, the setting is canceled.
To cancel the dimmer
Repeat the above and select "OFF" in step 2 .
Setting the clock
Use the remote.
1 Press CLOCK/TIMER/SET.
Go to step 3 when the time appears and the 'hour' flashes.
2 Press r or t repeatedly until "CLOCK
SET" appears in the display and then press
ENTER.
3 Press r or t repeatedly to set the hour
and then press ENTER.
4 Press r or t repeatedly to set the minute
and then press ENTER.
The time display stops flashing and the clock starts from
00 seconds.
•MULTI JOG is also available in place of r or t.
To display the time
Press DISPLAY on the remote. The time will be displayed for
6 seconds.
Tip:
"AM 12:00" indicates midnight and "PM 12:00" noon.
If "- -:- -" appears when the unit is turned off
There has been a power interruption. Re-set the clock.
En
9