IKEA VAPPEBY Manual Del Usuario página 11

Getting started
Connect a USB-C cable to the input port and the other end to a power source
(a computer or a power supply) to charge your product before the first
use and whenever the LED is flashing red to indicate a low battery. When
charging, the LED light will remain solid red if the speaker is off and will turn
off when the battery is fully charged.
Recommended power supply:
5.0 VDC, 1.0 A (Not included)
Speaker functions
Turning On/Off
Press and hold the Power button (1) to turn your speaker On/Off.
Play/Pause
A short press on the Power button will play or pause music.
Auto-off
If the speaker is not paired to any device, it will turn off automatically after
5 minutes. If the speaker is paired but no music is playing, it will turn off
automatically after 20 minutes.
Bluetooth pairing
To pair your speaker to a source device, the speaker must be in Bluetooth
pairing mode. To pair, open the Bluetooth setting on your source device and
connect to "VAPPEBY Portable".
The speaker will enter Bluetooth pairing mode automatically the first time it
is powered on, and any time that a previously paired device cannot be found.
Factory reset
To remove previous Bluetooth pairings, reset the speaker by pressing and
holding the button (1) for more than 5 seconds. Successful factory reset is
confirmed by the LED flashing red and with an audible sound.
Alternatively, go to the Bluetooth menu on your source device and unpair.
11