Advanced Bionics CI Q30 Guia Del Usuario página 40

If you select T-coil, make sure you are synced to a loop, myLink, or Roger myLink. Provide
a.
input to the FM transmitter or Roger Microphone to assess audio quality.
If you select Wireless, you will be listening to whatever audio source is being streamed
b.
through the ComPilot (i.e. Bluetooth device, FM/Roger, battery-operated device, etc.).
To begin the process, have the ComPilot turned on and the desired source streaming. It
is a good idea to turn the volume down on any device that is directly connected to the
ComPilot. If listening to FM/Roger input, connect the wireless FM/Roger receiver to the
Europort located on the ComPilot or to the PowerCel 170 battery and synchronize it with
the FM transmitter or Roger Microphone. Provide input to the FM transmitter or Roger
Microphone to assess audio quality.
Once the listening check is complete,
disconnect the module from the battery.
To close the Naída CI Listening Check when
not in use, remove the earbuds and grasp
the grip indents on the side of the Naída
CI Listening Check with one hand while
grasping the processor and battery interfaces
with the other hand. Carefully pull your
hands apart until the two pieces disconnect.
10
12
Remove the processor from the module.
Reconnect the battery to the processor,
and select the desired settings for use.
Turn one piece 90 degrees, aligning the
AB logo piece to slide into the other piece.
Naída CI Q30 Sound Processor User Guide
11
13
39