Using The Telephone - Advanced Bionics CI Q30 Guia Del Usuario

Push them together until they snap into place.
The Naída CI Listening Check requires a charged power source to function
NOTE:
correctly. If the power source being used to conduct the listening check has been
depleted to an inadequate charge level, the user will not be able to complete the task.
If the user attaches a discharged rechargeable PowerCel, AAA PowerPak or Off-the-Ear Power
Option, a solid red LED will light up on the Naída CI Q30.
If the user attaches depleted Zn-Air batteries, the sleep mode LEDs will be shown on the
Naída CI Q30 (orange LED blinks twice every three seconds) or, if the cartridge is completely
discharged, no LEDs will be shown and no sound will be heard through the Listening Check
earbuds.

Using the Telephone

There are a variety of ways to use the telephone with the Naída CI Q30 sound processor.
Consult a hearing care professional for recommendations regarding telephone use and which
of the following options are best:
Use the telephone receiver. The telephone can be used by placing the telephone receiver
•
directly over the T-Mic 2, processor microphones or headpiece microphone, if activated. It is
sometimes necessary to try different phones and providers, particularly when cellular phones
are used, in order to find the optimal telephone signal.
Use T-coil. The T-coil is programmable by a hearing care professional in the SoundWave™
•
fitting software. If there are any questions about whether it is activated and in what program,
please contact the implant center. When using the T-coil it may be necessary to move the
phone receiver around the Naída CI Q30 to see where it works best.
Use Bluetooth®. Any Bluetooth compatible device can be synced to the ComPilot to stream
•
phone calls directly to the Naída CI Q30. The microphone for the speaker is located on the
ComPilot, so the phone can be up to 15 - 30 feet (5 - 10 meters) away and still be in use.
40
Naída CI Q30 Sound Processor User Guide
14