Descargar Imprimir esta página

Jonsered FR 2318 FA 4x4 Manual De Usuario página 9

Publicidad

Idiomas disponibles

Idiomas disponibles

Keep the battery out of reach for children.
Charge the battery in a space with good airflow.
Keep flammable materials at a minimum clearance
of 1 m when you charge the battery.
Discard replaced batteries. See
27 .
Explosive gases can come from the battery. Do not
smoke near the battery. Keep the battery away from
open flames and sparks.
Safety instructions for maintenance
WARNING: The product is heavy and can
cause injury or damage to property or the
adjacent area. Do not do maintenance on
the engine or the cutting deck without these
conditions:
The engine is off.
The product is parked on a level surface.
The parking brake is applied.
The ignition key is removed.
The cutting deck is disengaged.
The ignition cables are removed from the
plugs.
WARNING: The exhaust fumes from the
engine contain carbon monoxide, an
odourless, poisonous and very dangerous
gas. Do not run the product in closed spaces
or spaces with not sufficient air flow.
WARNING: Read the warning instructions
that follow before you use the product.
Introduction
WARNING: The drive belt tension spring can
break and cause injury. Wear protective
glasses when you attach or remove the
cutting deck.
Read the assembly instructions in the owner's manual
carefully. A label on the inner side of the front cover on
the product, also shows how to attach and remove the
cutting deck.
To attach the cutting deck
1. Park the product on level ground.
2. Apply the parking brake.
3. Set the cutting height lever in the servicing position.
807 - 001 - 13.06.2018
Disposal on page
Assembly
For best performance and safety, do maintenance
on the product regularly as given in the maintenance
Maintenance schedule on page 14 .
schedule. See
Electrical shocks can cause injuries. Do not touch
the cables when the engine is on. Do not do a
function test on the ignition system with your fingers.
Do not start the engine if the protective covers are
removed. There is a high risk of injury caused by
moving or hot parts.
Let the product become cool before you do
maintenance near the engine.
The blades are sharp and can cause cuts. Wind
protection around the blades or use protective
gloves when you do work on the blades.
Always put the cutting deck in servicing position to
clean it. Do not park the product near the edge of a
ditch or slope to get access to the cutting deck.
CAUTION: Read the caution instructions
that follow before you use the product.
Do not turn over the engine if the spark plug or
ignition cable is removed.
Make sure that all nuts and bolts are tightened
correctly and that the equipment is in good condition.
Do not change the adjustment of governors. If the
engine speed is too high, the product components
can become damaged. See
28 for highest permitted engine speed.
The product is approved only with the equipment
supplied or recommended by the manufacturer.
4. Set the lift lever for the cutting deck in the mow
position.
Technical data on page
9

Publicidad

loading