Publicidad
Idiomas disponibles
Idiomas disponibles
Troubleshooting
Fills with the Wrong
Temperature
Water
Cycle Selector
Advances Through Off
• Turn both faucets on fully.
• If equipped with a temperature
selector knob, be sure it is set directly on a
temperature
setting and not between settings.
• Make sure temperature
selection
is correct.
• If Auto Temperature
Control (select models) is selected, cold water may feel warmer
than cold water from the tap. (See page 7-8).
• Make sure hoses are connected
to correct faucets and inlet connections.
Be sure
water supply is regulated
correctly. Flush water line before filling washer.
• Check the water heater. It should be set to deliver a minimum
120° F (49 ° C) hot
water at the tap. Also check water heater capacity and recovery rate.
• Disconnect
hoses and clean screens. Hose filter screens may be plugged.
• Extra Rinse (select models) is selected.
14
Publicidad
