Setting The Close Limit Switch; Self Learning Of The Forces; Adjusting The Sensitivity - V2 AZIMUT Manual Del Usuario

9.2 - SETTING THE CLOSE LIMIT SWITCH

+
-
-
Press the key,
2
the display shows

9.3 - SELF LEARNING OF THE FORCES

+
-
-
Press the key,
3
the display shows
m
PLEASE NOTE: On completion of the procedure, it is
possible to exit the programming procedure, storing the
parameters set: press and hold the
until the segments of the display illuminate one at a time
0
until showing
9.4 - ADJUSTING THE SENSITIVITY (DEFAULT: 4)
This menu allows the sensitivity of the device, when the door encounters an obstacle, to be increased or decreased.
This parameter is already set to a mid value (4) that should be ideal for the majority of installations.
+
-
-
Press the key,
4
the display shows
+
-
Press the key to save
the settings.
4
The display shows
+
-
Press the key:
2
flashes
+
-
Press the key:
3
flashes - the door opens
key for 5 seconds
+
-
Press the key:
C
flashes
m
PLEASE NOTE: if this parameter is modified, then on completion of programming,
it is necessary to conduct a complete open/close cycle, during which the control unit
automatically conducts a fresh force training operation (during this cycle, the motor works
at maximum force, so particular attention must be paid).
Press and hold the
+
(the door opens)
-
or (the door closes)
key to reach the fully
close position
When the door stops, press
the key to confirm.
Press the key once
more to continue - the
door closes
1 2
+
Select the desired level using the
- 22 -
+
-
When the door reaches the
closed position press the
key to save the settings
+
-
When the door stops, press
the key to save the
settings.
The display shows
3 4 5
-
+ -
and keys
+
-
+
-
3
6