Publicidad
Idiomas disponibles
Idiomas disponibles
GENERAL INFORMATION
INTRODUCTION
WARNING
Read all the safety information and instructions that were supplied
with the parallel milling guide. Failure to comply with safety informa-
tion and instructions can lead to electric shock, fire and/or serious in-
jury.
Keep the operating instructions in a safe place for future reference.
This manual describes the parallel milling guide (the "product") for use on
wolfcraft machine tables art. no. 6900, 6902, 6906, 6907 and 6918. The
machine tables are used in conjunction with the parallel milling guide as
stationary routing tables.
The purpose of the figures in this manual is to help you better understand
the topics and step sequences. The representations in the figures are ex-
amples and may deviate slightly from the actual appearance of your
product.
The term "power tool" used in the safety information refers to electric tools
operated with mains power (with mains power cable).
SYMBOLS AND MEANINGS
WARNING
WARNING
...means that there is risk of severe to life-threatening injury.
CAUTION
CAUTION
...means that there is risk of minor to moderate injury.
NOTICE
NOTICE
...indicates important information (e.g. risk of property damage), but not
hazards.
Information
This symbol indicates information that helps you to quickly and
safely perform your tasks.
Warning of a danger
This symbol indicates a general hazard that, if not avoided,
could result in injury.
Observe instructions!
This symbol indicates that the operating instructions must be
followed.
Wear safety goggles!
This symbol indicates that you have to wear safety goggles.
Wear ear protection!
This symbol indicates that you have to wear ear protection.
EN
Wear protective mask
This symbol indicates that you have to wear a protective mask.
Disconnect mains plug
Pull the plug when the device is not in use.
Observe direction of routing!
Route only in up-cut mode.
SAFETY
SAFETY INFORMATION FOR ROUTERS
– Apart from this machine-specific safety information, also ob-
serve the safety information for the router and the machine
table used.
– Always be aware that the workpiece may unexpectedly get out of
control during the routing process and be kicked back.
– Do not use the machine table for curved work.
– Do not use routers with a rating of more than 1800 W and a voltage
of more than 230 V.
– Keep in mind that the feed must be against the direction of rotation
of the router bit.
– Use only sharp and properly maintained routing tools that have been
set in accordance with the tool manufacturer's instructions.
– Observe the data concerning the minimum/maximum speed and the
direction of rotation indicated directly on the equipment and tools
used, or on their packaging, or as detailed in the operating instruc-
tions.
– Please be aware that the improper use of routing tools, of work-
pieces and of the guiding devices for the workpiece may cause dan-
gerous situations.
– When routing, keep your hands away from the routing tool.
– Use table pressure shoes in addition to the parallel milling guide
while routing.
– Support long workpieces on the receiving side to prevent dangerous
situations caused by accidental tipping over. The support must rest
on stable ground and have the same height as the machine table,
e.g. the roller trestle (art. no. 6102300).
– Only process workpieces that, considering their weight and size, can
be held and guided safely by one person.
– Choose the correct speed that is appropriate for the tool and work-
piece. Refer to the manual for your router for exact speed specifica-
tions.
– From the spacer rings supplied with the machine table, select one
appropriate for the size of the router tool. Safe work requires select-
ing the smallest possible spacer ring.
– Make sure that the parallel milling guide is properly mounted and all
screws/handle screws are tightened.
– Insert the router shank into the collet up to the marking. Follow the
instructions in the manual for your router to ensure proper mounting
of the router bit in the router.
– Do not use router bits with a diameter exceeding 27 mm.
– Do not make any alterations or modifications to this product.
26
Publicidad
