Descargar Imprimir esta página

Craftsman 917.28852 Manual Del Operador página 20

Ocultar thumbs Ver también para 917.28852:

Publicidad

Idiomas disponibles

Idiomas disponibles

CLEANING
Clean engine,
battery, seat, finish, etc.
of all foreign
matter.
Clean debris from steering plate. Debris
can restrict clutch]brake pedal shaft move-
ment, causing
belt slip and loss of drive.
A CAUTION:
Avoid all pinch points and
movable
parts
Clean
/'
'_YS_=_.
X
Plate_S_
Steering System, Dash, Fender
and Mower Not Shown
Keep finished
surfaces
and wheels free
of al! gasoline,
oil, etc.
Protect painted surfaces with automotive
type wax,
Except for the washout
port (if equipped),
we do not recommend
using a garden hose
or pressure
washer
to clean the outside
of
your tractor unless the engine and transmis-
sion are covered
to keep water out. Water
in engine or transmission
will shorten
the
useful life of your tractor.
Use compressed
air or a leaf blower to remove grass, leaves
and trash from outside
tractor and mower.
DECK WASHOUT
PORT
Your tractor's deck is equipped with a washout
port as part of its deck wash system. It should
be utilized after each use.
1.
Drive the tractor to a level, clear spot on
your lawn, near enough to a water spigot
for your garden hose to reach.
IMPORTANT:
Make
certain
the tractor's
discharge chute is directed AWAY from your
house, garage, parked cars, etc. Remove bag-
ger chute or mulch cover if attached.
Hose
_.-1P _
WashoutPort
Nozz[e....---'C--" / /
(_
t
._Adapter
_
_c
2.
Make sure the attachment
clutch control
is in the "DISENGAGED"
position, set
the parking brake, and stop the engine.
3.
Thread the nozzle adapter (packaged with
your tractor's Operator's Manual) ontothe
end of your garden hose.
4.
Pull back the lock collar of the nozzle
adapter and push the adapter onto the
deck washout port at the left end of the
mower deck. Release the lock collar to
lock the adapter on the nozzle.
IMPORTANT:
Tug hose ensuring connection
is secure.
5,
Turn the water on.
6.
While sitting in the operator's position on
the tractor, re-start the engine and place
the throttle lever in the Fast "_"
position.
IMPORTANT: Recheck the area to ensure the
area is clear.
Ensure no children
are in the:
area while cleaning the deck.
7.
Move the tractor's attachment clutch con-
trol to the "ENGAGED" position. Remain
in the operator's
position withthe cutting
deck engaged until the deck is cleaned,
8.
Movethetractor's
attachment clutch con-
trol to the "DISENGAGED"
position. Turn
the ignition keyto the STOP position totum
the tractor's engine off. Turn the water off.
9.
Pull back the lock collar of the nozzle
adapter to disconnect the adapter from
the nozzle washout port.
10. Move the tractor to adry area, preferably
a concrete or paved area. Piece the at-
tachment clutch contro!inthe"ENGAGED"
position to remove excess water and to
help dry before putting the tractor away.
_IbWARNING:
A broken or missing washout
fitting could expose you or others to thrown
objects from contact with the blade.
* Replace broken or missing washout fitting
immediately,
prior to using mower again.
,
Plug any holes in mower with bolts and
Iocknuts,
2O

Publicidad

loading