Descargar Imprimir esta página

Sony XAV-9550ES Manual De Instrucciones página 15

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 86
Memory hold connection
When the yellow power supply lead is connected,
power will always be supplied to the memory
circuit even when the ignition switch is turned off.
Speaker connection
• Before connecting the speakers, turn the unit off.
• Use speakers with an impedance of 4 Ω to 8 Ω,
and with adequate power handling capacities to
avoid damage.
• Set [Speaker Configuration] in [Sound] to [Front &
Rear] or [Front 2-way] depending on your speaker
system.
• When connecting a speaker system for the Front
2-way mode, do not set [Speaker Configuration] in
[Sound] to [Front & Rear]. This may cause damage
to the speakers.
Power connection diagram
Check your car's auxiliary power connector and
match the connections of leads correctly
depending on the car.
Auxiliary power connector
Common connection
Red
Yellow
continuous power
12
supply
15
switched power supply
When the positions of the red and yellow
leads are inverted
Red
Yellow
12
switched power supply
continuous power
15
supply
Red
Yellow
Yellow
Red
Red
Yellow
Yellow
Red
For cars without ACC position
Red
Yellow
After matching the connections and switching
power supply leads correctly, connect the unit to
the car's power supply. If you have any questions
and problems connecting your unit that are not
covered in this manual, consult the car dealer.
Installing the microphone
To capture your voice during handsfree calling, you
need to install the microphone .
Clip (not supplied)
Cautions
• It is extremely dangerous if the cord becomes
wound around the steering column or gearstick.
Be sure to keep it and other parts from interfering
with your driving operations.
• If airbags or any other shock-absorbing
equipment are in your car, contact the store where
you purchased this unit or the car dealer before
installation.
Notes
• When mounting on the dashboard, remove the visor clip
carefully from the microphone , then attach the flat-
mount base  to the microphone .
• Before attaching the double-sided tape , clean the
surface of the dashboard with a dry cloth.
Red
Yellow
15
GB

Publicidad

loading