Publicidad
Idiomas disponibles
Idiomas disponibles
*1 Not supplied
*2 Speaker impedance: 4 Ω to 8 Ω × 4
*3 RCA pin cord (not supplied)
*4 Power amplifier (not supplied)
*5 Subwoofer (not supplied)
*6 Depending on the type of car, use an adaptor for a
steering wheel remote control (not supplied). For details
on using the steering wheel remote control, see "Using
the steering wheel remote control" (page 16).
*7 Depending on the type of car, use an adaptor (not
supplied) if the antenna (aerial) connector does not fit.
*8 Whether in use or not, route the microphone input cord
so it does not interfere with driving operations. Secure
the cord with a clamp, etc., if it is installed around your
feet.
*9 For details on installing the microphone, see "Installing
the microphone" (page 15).
*10 Connect when using Apple CarPlay with a wireless
connection.
*11 Front speaker/Front tweeter
If [Speaker Configuration] in [Sound] is set to [Front &
Rear], connect the front speaker. If [Speaker
Configuration] in [Sound] is set to [Front 2-way], connect
the front tweeter.
*12 Rear speaker/Front woofer
If [Speaker Configuration] in [Sound] is set to [Front &
Rear], connect the rear speaker. If [Speaker
Configuration] in [Sound] is set to [Front 2-way], connect
the front woofer.
*13 Set [Antenna Power] to [On] (default) or [Off] depending
on the type of DAB antenna (aerial) (not supplied).
Max. supply current 0.1 A
Making connections
If you have a power antenna (aerial) without a relay
box, connecting this unit with the power supply
leads may damage the antenna (aerial).
To the car's speaker connector
1
Rear speaker
(right)
2
3
Front speaker
(right)
4
5
Front speaker
(left)
6
7
Rear speaker
(left)
8
14
GB
Purple
Purple/black
striped
Gray
Gray/black striped
White
White/black
striped
Green
Green/black
striped
To the car's power connector
continuous power
12
supply
power antenna (aerial) /
13
power amplifier control
(REM OUT) (MAX 0.4 A)
switched illumination
14
power supply
15
switched power supply
16
ground (earth)
maintain the accurate
location of your car
17
when using Apple
CarPlay with a wireless
connection
To the parking brake switch lead
The mounting position of the parking brake
switch lead depends on your car.
Be sure to connect the parking brake lead (light
green) of the power supply leads to the
parking brake switch lead.
Parking brake switch lead
Hand brake type
To the +12 V power terminal of the car's rear
lamp lead (only when connecting the rear
view camera)
To an interruption signal (+3.3 V to +12 V) to
display the picture from CAMERA IN 1 and
CAMERA IN 2
Note
REVERSE IN, EXT IN 1, and EXT IN 2 interrupt detections
have the following priority levels.
REVERSE IN always has priority; if both EXT IN 1 and
EXT IN 2 occur at the same time, EXT IN 1 has higher
priority.
Camera Connection
Installation of cameras (not supplied) is required
before use.
Connect the camera power cord (lead) to the
accessory power terminal.
Yellow
Blue/white striped
Orange/white
striped
Red
Black
Pink
Foot brake type
Publicidad
