Publicidad
Idiomas disponibles
Idiomas disponibles
Configure the instrument
About this task
Note: You can only install a Node Locked option license one time. If you need to reinstall an uninstalled Node Locked license,
contact Tektronix Customer Support.
These instructions only support options that are enabled by installing a software license. Some product upgrades, such as the
5/6 Series MSO SSD upgrades (Embedded OS or Microsoft Windows 10) and 5 Series MSO bandwidth upgrades to 2 GHz,
are not supported by this document. These upgrades either have their own installation instructions, or require that you send the
instrument to a Tektronix support center for new hardware and calibration.
Procedure
1.
Follow the instructions you received to download the upgrade license file (<filename>.lic).
2.
Copy the license file or files to a USB memory device.
3.
Insert the USB drive into the powered-on oscilloscope for which the upgrade was purchased.
4.
Select Help > About.
5.
Select Install License to open the Browse License Files dialog box.
6.
Find and select the upgrade license file to install.
7.
Select Open. The oscilloscope installs the license and returns to the About screen. Verify that the installed license was added to the
Installed Options list.
8.
Repeat steps
5
through
9.
Power cycle the oscilloscope to enable the installed upgrades.
10. If you installed a bandwidth upgrade, rerun signal path compensation (SPC). Then carefully remove the model/bandwidth label from
the lower-left corner of the front panel and install the new model/bandwidth label that was sent through normal mail channels as part
of the upgrade purchase.
Set the time zone and clock readout format
Set the time zone to your region so that saved files are marked with the correct date and time information. You can also set the time format
(12 or 24 hour clock).
Procedure
1. Double-tap the Date/Time badge (bottom-right of screen) to open the configuration menu.
2. To turn off showing the date and time on the screen, tap Display button to Off.
To turn on date/time display again, double-tap in the blank area where the date/time badge was displayed to open the configuration
menu, and set the Display button to On.
3. Select a time format (12 Hour or 24 Hour).
4. Tap the Time Zone field and select the time zone that applies to your location.
5. Tap anywhere outside of the menu to close it.
42
7
for each upgrade license file that you purchased and downloaded.
Publicidad
