Husqvarna PG 400 Manual Del Usuario página 8

Emergency stop
The emergency stop is used to quickly stop the motor.
The emergency stop at the product breaks the mains
power supply.
To do a check of the emergency stop
1. Push the emergency stop button (A) and make sure
that the motor stops.
A
Introduction
WARNING:
product, you must read and understand the
safety chapter.
8
B
Operation
Before you operate the
2. Turn the emergency stop button clockwise (B) to
disengage.
Safety instructions for maintenance
WARNING:
instructions that follow before you use the
product. Save all warnings and instructions
for future operations.
• Keep all parts in good condition and make sure that
all fixtures are correctly tightened.
• Do not use a product that is damaged or does
not operate correctly. Do the safety checks,
maintenance and the servicing as given in this
manual. All other maintenance work must be done
by an approved servicing dealer.
• Stop the product and disconnect the power plug
when you replace the diamond tools. Push the
ON/OFF switch to 0.
• Do the inspection and/or maintenance with the motor
stopped and the power plug disconnected.
• Do the maintenance to make sure that the product
operates correctly. Refer to
page 16 .
Read the warning
Daily maintenance on
2258 - 002 - 25.10.2023