Publicidad
Idiomas disponibles
Idiomas disponibles
KUKKO tool factory
Series 69, 70, 71, K-222
pull
EN
the bearing
after removal!
69-a · 69-b · 69-C
90°
24
Ball bearing removal
pressure
pull
must be
replaced
new bearing!
pressure
the new bearing will
be installed again.
The cage of the damaged ball bea-
ring needs to be drilled so that the
hemispheres of the pulling parts can
be screwed in.
· There arise drilling chips
Bearing installation
The new bearing will be installed again.
Our series 71 sets can be used for this purpose
(see instructions starting on page 20).
Serie 69
A world in motion
since 1919!
Publicidad
