Publicidad
Idiomas disponibles
Idiomas disponibles
Ball bearing installation with a soft-head hammer (series 71)
www.KUKKO.com
1. Using the selection table in the tool case and the ISO number of the ball bearing
(see the table on page 33), select the right impact ring and the right impact sleeve.
2. Plug the impact ring and the impact sleeve together.
3. Insert the bearing into the bearing sleeve.
4. Using short, powerful blows, drive the bearing into place.
5. The bearing has been driven in.
6. A new or used bearing has been press-fitted again.
KUKKO tool factory
Series 69, 70, 71, K-222
EN
33
Publicidad
