KUKKO 69 Serie Instrucciones De Uso página 40

KUKKO tool factory
Series 69, 70, 71, K-222
Operating instructions series K-222
seal pulling set (radial shaft seal)
For the extraction of radial shaft seals, oil seals, sealing sleeves, seals, bearing seals and shaft
EN
gaskets.
the following set is available in series K-222:
K-222-1/7
application example:
40
Use on bearing seal
1. To avoid chips from drilling, use an awl to punch a small hole in the sheet metal
cover of the oil seal.
2. Choose a suitable extension.
3. Thread the special self-tapping screw into the extension.
4. Using a suitable extension, screw the self-tapping screw into the seal.
5. Tighten the extension using an open-end wrench.
6. Then mount the slide hammer on the extension.
A world in motion
since 1919!