KUKKO 69 Serie Instrucciones De Uso página 34

KUKKO tool factory
Series 69, 70, 71, K-222
Ball bearing installation with a press (series 71)
EN
34
1. Using the selection table in the tool case and the ISO number of the ball bearing
(see the table on page 33), select the right impact ring and the right impact sleeve.
2. Put the bearing location on a solid, flat surface beneath your workshop press.
3. Place the bearing flat on the bearing location (you may need to tap the bearing
into place with light hammer blows). Position the press ram flat on the bearing.
4. Slowly increase the pressure with the workshop press.
5. Continue until the bearing is fully seated.
6. Fully pressed bearing.
A world in motion
since 1919!