Maytag WT-TOD Guia Del Usuario página 12

OVEN RACKS
> Clean with soapy water.
> Remove stubborn soil with cleans-
ing powder or soap-filled scouring
pad. Rinse and dry.
PLASTIC FINISHES
TRIM & END CAPS
> When cool, clean with soap and
water, rinse and dry.
> Use a glass cleaner and a soft
cloth.
NOTE: Never use oven cleaners, abra-
sive or caustic fiquid or powdered
cleansers on plastic finishes. These
cleaning agents will scratch or mar fin-
ish.
NOTE: To prevent staining or discolor-
ation, wipe up fat, grease or acid (to-
mato, lemon, vinegar, milk, fruit juice,
marinade) immediately with a dry pa-
per towel.
SEALED GAS BURNERS
> Allow burner to cool. Wash with
soapy water and a plastic scouring
pad. For stubborn soils, clean with
a soap-filled, nonabrasive pad.
> Clean gas ports, especially the port
below the ignitor, with a straight pin
or a soft bristle brush.
Be careful not to get water into
burner ports.
When cleaning, use care to prevent
damage to the ignitor. If the ignitor
is soiled, wet or damaged, the sur-
face burner will not light.
OVEN DOOR
Do not place excessive weight
on or stand on an open oven
door. This could cause the
range to tip over, break the
door. or injure the user.
Do not attempt to open or close
door or operate oven until door
is properly replaced.
Never place fingers between
hinge and front oven frame.
Hinge arms are spring mount-
ed. If accidentally hit, the hinge
will slam shut against oven
frame and could injure your fin-
gers.
TO REMOVE:
,
,
When cool,
open the
oven door
to the first
stop posi-
tion (opened about four inches).
Grasp door at each side. Do not
use the door handle to lift door.
3. Lift up evenly until door clears
hinge arms.
TO REPLACE:
1. Grasp door at each side.
2. Align slots in the door with the
hinge arms on the range.
,
Slide the door down onto the hinge
arms until the door is completely
seated on the hinges. Push down
on the top corners of the door to
completely seat door on hinges.
Door should not appear crooked.
NOTE: The oven door on a new range
may feel "spongy" when it is closed.
This is normal and will decrease with
use.
OVEN LIGHT
> Disconnect power to range
before replacing light bulb.
> Use a dry potholder to prevent
poss!ble harm to hands when
replacing bulb.
i
> Be sure bulb is cool before
touching bulbl
> Do not touch hot bulb with a
damp cloth as this may cause
the bulb to break.
TO REPLACE OVEN LIGHT BULB:
1. Remove light bulb.
2. Replace with a 40 watt appliance
bulb.
3. Reconnect power to range. Reset
clock.
OVEN WINDOW
(Select Models)
,
Do not use abrasive cleaning
agents such as steel wool scouring
pads or powdered cleansers as
they may scratch the glass.
2. Do not hit the glass with pots, pans,
furniture, toys or other objects.
3. Do not close the door until the oven
racks are in place.
Scratching, hitting, jarring or stressing
the glass may weaken its structure
causing an increased risk of breakage
at a later date.
]]