Publicidad
Idiomas disponibles
Idiomas disponibles
inserted into the electrical outlet.
Remember that electrical outlets also
deteriorate due to wear and tear and
continuous use.
- If the supply cord is damaged, it must be
replaced by the manufacturer or authorized
service centre or qualified person in order to
avoid risks.
- Check if the heater or the electric cable has
been damaged during transport.
- When switching the heater on for the first
time, allow it to run at full power for a few
hours for it to work properly. During this
operation, keep it in a ventilated environment
to eliminate the smell that will possibly come
out of the brand new heater.
Soft crackling sounds are normal during the
heater's first operation.
SAVE THESE
INSTRUCTIONS
FOR HOUSEHOLD USE ONLY
DESCRIPTION
A
thermostat
B
switches
C
green pilot light
D
COMFORTEMP button
E
cable support
F
wheel
USE
Fitting the wheels ("easy wheel" system)
Turn the heater upside down on a rug or other soft surface
to avoid damaging your paint. Fully unfold the castors by
turning them outwards (Fig. 1). Turn the heater back to an
upright position.
Fig. 1
Precautions: Always use the heater in an upright position
(the wheels below and the controls at the top). Any other
position can be a risky situation!
Watts economizer
For more economical use, the two keys can be used
individually, once the unit has reached operating
temperature.
-
button in position «l»= Minimum power (pilot light
on);
-
button in position «ll»= Intermediate power (pilot light
on)
-
both buttons in position «l» «ll» = maximum power
(indicator lights on)
With pilot lights ON, the heater is ON!
Location
Place heater on the floor beneath the coldest window in the
room, or any other location. Your heater will reduce the effect
of cold drafts. The heater should not be placed immediately
below a fixed power outlet. Do not use the heater in a room
whose surface is less than 4 m
Connection
The heater must be properly connected to a polarized
127/220 socket (alternating current) in perfect working
condition. Keep clothing or sheets, furniture and flammable
materials away from the outlet.
Turning On
Turn the thermostat clockwise to its maximum position.
Push down both switches. The switch lights stay on
independently of the thermostat cycling. When the room
reaches the desired temperature, slowly turn the thermostat
knob counterclockwise until you hear a "click". This should set
your heater to maintain the desired temperature by cycling
on and off as required.
11
2
.
Publicidad
