Maytag HAVS-1 Guía De Uso Y Cuidado página 11

Special Features
Automatic Lint Fimtering System
The Lint Fi]tedng System does not require
cleaning.
Wash and rinse water is filtered and re-filtered
continuously to trap lint shed by most fabrics during
the agitation cycb before it can be redeposited on the
wash load. The engineered hob design on the wash
basket in conjunction with water flow produced by the
agitator, traps lint away from the clothes between the
inner wash basket and the outer tub. Lint is
automatically fhshed from the washer during the spin
cycJe.
Safety Spin
If for any reason you open the washer lid when the
washer is in a spin or extract period, the operation will
immediately stop. This is for your personal safety. If
your washer does not stop, call your service technician
immediately. When the lid is closed, the operation will
automatically resume.
Unbalanced
Spin
Load Compensator
Your new washer is designed to handle out-of-balance
loads without shutting down or interrupting the
washing cycle.
For this reason, the cycle will always be completed. If
heavier fabrics in such out-of-balance loads should
ever contain excessive moisture at the completion of
the cycle, redistribute the clothes in the washer and
reset the control dial for the final spin period.
Overload Protector
A built-in protector automatically shuts off the washer
motor in case of an overload. This can occur if:
The bad being washed is too heavy.
Too many appliances are plugged into the line
operating your washer.
A low voltage condition exists on the line.
Lid is opened and closed repeatedly.
The overload protector permits the washer to start
again when the motor has cooled to a safe operating
tern peratu re.
If the motor stops repeatedly, ca[[ your service
technician.
10