Publicidad
Idiomas disponibles
Idiomas disponibles
1
2
3
The clock is displayed.
(The ":" between the hours and minutes
flashes.)
When the power cord is plugged
into an AC outlet
for the first time after purchase
or when the clock setting
is
canceled
due to a power
failure,
the entire
clock
display
flashes.
Press CLOCK.
When using the remote control,
press CLOCK
while pressing
SHIFT.
Within 4 seconds, turn MULTI JOG to designate
the hour and the minute.
Turning
MULTI JOG changes
both the hour and the minute.
+<
or -
is also available
instead
of MULTI JOG. Holding
these buttons
down will vary the time rapidly.
Press ENTER or Il.
The clock starts from 00 seconds.
To restore an original clock setting
Press CLOCK
before completing
step 3 to restore the previous
time setting. This cancels
any new setting.
To view the clock
when
another
display
is in the display
Press CLOCK.
The time is displayed
for 4 seconds
and then the
original
display
reappears.
However,
the
clock
cannot
be
displayed
during
recording.
To switch to the 24-hour standard
Press the CLOCK
and then press
within 4 seconds.
Repeat the same procedure to restore the 12-hour
standard.
If the clock
display
flashes
This is caused by a power interruption.
The current time needs
to be reset.
If power is interrupted
for more than approximately
24 hours,
all settings
stored in memory
after purchase
need to be reset.
The unit can be turned
off automatically
at a specified
time.
Use the remote control.
7
Press SLEEP while pressing SHIFT.
2 Within 4 seconds, turn MULTI JOG to specify the
time until the power is turned off.
The time changes
between
5 and 240 minutes
in 5-minute
steps.
+
and >
are also available
instead
of MULTI JOG.
Specified
time
To check
the time remaining
until the power
is turned
off
Press SLEEP
once while pressing
SHIFT. The remaining
time is
displayed
for 4 seconds.
To
cancel the sleep timer
Press SLEEP
twice while pressing
SHIFT so that "SLEEP
oFF
appears
on the display.
If the power-economizing
mode
(page 7) is on, all the display
lights turn off when the power
is turned
off. To view the clock,
press CLOCK
so that the time is displayed for 4 seconds.
26
ENGLISH
Publicidad
