Maytag MAH-1 Guía De Uso Y Cuidado página 10

Washers can bedamaged ifwater i snotremoved from
hosesand internalcomponents b eforestorage.
Prepare thewasher for storage a sfollows:
• Select the cotton/sturdy and quick setting and
add one cup of bleach to the detergent dispenser
without clothes in the tumbler. Run the clothes
washer through a complete cycle.
Turn the water faucets off and disconnect the inlet
hoses.
Disconnect the clothes washer from the electrical
supply and leave the washer door open to let air
circulate inside the tumbler.
If the washer has been stored in below-freezing
temperatures, allow time for any water left over in
the washer to thaw out prior to use.
For information on long-term storage or storage of your washer during extreme cold temperatures,
call Maytag Customer Assistance toll-free at 1-800-688-9900 USA or 1-800-688-2002 Canada.
U.S. customers usingTTY for deaf, hearing impaired or speech impaired, call 1-800-688-2080.
i EVERSE THE
DOOR
Clothes washer door swing direction can be changed using the following procedure:
I) Swing door fully open and support it while removing four hinge screws (which hold hinges to door assembly).
2) Move the door to a work surface and transfer four door screws to the opposite side of the door assembly.
3) Remove one screw holding top hinge to cabinet and one screw holding top hinge cover to cabinet (opposite side).
4) Remove hinge and bracket from cabinet by moving them up and down to a position where they are released.
5) Install hinge and bracket in swapped locations and drive screws to attach them securely to the cabinet.
6) Compare top hinge and top bracket to bottom hinge and bottom bracket for correct hinge assembly position.
7) Repeat procedures 4 through 6 for bottom hinge to cabinet and bottom bracket to cabinet.
8) Support door in fully open position on hinge side and drive four screws to securely attach hinges to door assembly.
9) Close door and check to see that clothes washer operates properly.
Counter Sunk Screw _