Descargar Imprimir esta página

Maytag MAH-1 Guía De Uso Y Cuidado página 11

Ocultar thumbs Ver también para MAH-1:

Publicidad

Idiomas disponibles

Idiomas disponibles

II!IEFORE
YOU
CALL
For problem
laundry
solutions
(i.e. fabric
damage,
residue,
tangling)
and special
laundry
care
procedures,
see the
enclosed
LaunderingTips
booklet.
Use Max Extract
option.
Load
is Too Wet
at
• Try using a high efficiency detergent to reduce sudsing.
End of Cycle
Load is too small.Very small loads (one or two items) may become unbalanced and not spin
out completely.
Make sure door is firmly closed.
Make sure hose connections are tight.
Leaks Water
Make sure end of drain hose is correctly
inserted and secured to drain facility.
• Avoid overloading.
Use high efficiency detergent to prevent over-sudsing.
Check fuse or reset circuit breaker.
Straighten drain hoses. Eliminate kinked hoses. If there is a drain restriction,
call for service.
Won't
Spin
Close the door and push the start/pause
pad. For your safer7, washer will not tumble or
or Drain
spin unless the door is closed.
• After pressing the start/pause
pad, it will take 30 seconds before the clothes washer begins
to spin.The door must lock before spin can be achieved.
See "Tub is Completely
Full of Suds" below.
Plug cord into live electrical outlet.
Check fuse or reset circuit breaker.
Close door and push the start/pause
pad to start the clothes washer. For your safer7,wash-
Stops
er will not tumble or spin unless door is closed.
• This may be a pause or soak period in the cycle. Wait briefly and it may start.
Check screens on inlet hoses at the faucets for obstructions.
Clean screens periodically.
Run the clothes washer through another complete cycle using cold water.
Tub is Completely
Full of Suds
Reduce detergent amount for that specific load size, soil level and water hardness.
Use high efficiency or low sudsing detergent
specially formulated
for front load washers.
• Turn both faucets on fully.
Make sure temperature
selection is correct.
Make sure hoses are connected to correct faucets. Flush water lines.
Check the water heater. It should be set to deliver a minimum of 120°F (49°C) hot water at
the tap. Also check water heater capacit7 and recovery rate.
Fills with the
Disconnect
hoses and clean screens. Hose filter screens may be plugged.
Wrong
• When
warm
rinse
is selected,
only
the
final
rinse
will
be warm.
The
first
two
Temperature
rinses will be cold.
Water
• As the washer is filling, the water
temperature
may change as the automatic temperature
control
feature checks incoming water temperature.
This is normal.
• While
the washer is filling, you may notice just hot and/or just cold water going through the
dispenser when cold or warm wash temperatures
are selected. This is a normal function
of
the automatic temperature
control feature as the washer determines
the temperature
of the
water.
I 0
CONT.

Publicidad

loading