Vornado VMHi500 Guia Del Propietario página 6

CONTROLS
THERMOSTAT -/+
POWER ON/OFF
This heater has a dual display
feature and both displays are
synced. One display is integrated
into the carry handle. The other
display is located on the front of
the heater.
The displays illuminate when
powered on and as settings are
adjusted. After a selection is made
the displays dim after 20 seconds.
10 English
HOW TO USE
Before use, check appliance for visible damage. DO NOT USE THIS HEATER if there is evidence of damage. If any damage is found, contact
To change temperature display from
Vornado Air LLC at 1-800-234-0604.
Fahrenheit to Celsius, press and hold (-) and
( ) for three seconds.
1. Use integrated handle on top of heater for
MODE 2. Position heater so airflow is not obstructed.
High Heat (1500 watts)
3. Unwrap power cord from storage tray on back
Low Heat (750 watts) or
Fan Only
TIMER
4. Press the Power button
POWER INDICATOR LIGHT
Red light illuminates to
indicate the heater is on.
REMOTE
CONTROL
Convenience at
your finger tips.
5. Set timer to automatically power the unit off by
lifting and carrying.
of heater. Plug power cord into standard
grounded wall outlet.
and select Mode or
Fan Only . Room temperature will illuminate
on both displays. Set thermostat to desired
temperature using -/+. SET TEMP numbers
will flash on both displays as you adjust.
Once the selection is made it will flash for five
seconds, become constant for five seconds
and then returns to room temperature. The
displays will then dim after 20 seconds. Default
settings upon first use will be High Heat and set
temperature of 75 degrees.
. 0 will flash on both top and front
pressing
displays. Press to select the amount of time in
one-hour intervals, up to 12 hours. User can also
use -/+ to select the amount of time.
After a selection is made or after five seconds
of inactivity, the number selection will stop
flashing and become constant. It is then
displayed for five seconds, before room
temperature is displayed again. To cancel the
timer operation, select 0 hours or hold
for
three seconds.
The white indicator light on front display and
TIMER on top display will illuminate to indicate
the timer is on.
COOL DOWN
When you power off your heater while in
High or Low heat mode, it automatically
enters a cool down routine in which the
heating element turns off and the fan
exhausts remaining heat. During Cool
Down, both top and front displays count
down before powering off completely.
11
English