Publicidad
Idiomas disponibles
Idiomas disponibles
STORAGE
During the off-season or after extended periods of non-use, you may
choose to store your heater. To ensure long life of the product, it is
recommended to store your heater by following these instructions:
Cleaning is recommended before storage.
1. Unplug power cord, wrap cord and slide inside storage tray on
back of heater.
2. Cover, or place back in retail carton if available. This prevents
heater from accumulating dust over time.
3. Store heater in cool and dry location.
DISPOSAL
Dispose of all packaging
materials in an environmentally
responsible manner.
14 English
RESET HEATER
RESETTING YOUR VORNADO HEATER
Your Vornado Heater has a multilevel safety shut-off system designed
to prevent overheating. Overheating may occur when the inlets or
outlet are blocked. If this happens, the safety shut-off system cuts
power to the heater and you must manually reset the heater.
1. Power heater off, then unplug power cord.
2. Remove any obstructions.
3. Wait 5–10 minutes, allowing heater to cool down.
4. Plug in power cord and place heater in desired position.
5. Power heater On. Your Vornado Heater should now
function normally.
Note: If the safety shut-off system repeatedly shuts off your heater
or if it will not reset after following the above procedure, call
Vornado Consumer Services Department toll-free at
1-800-234-0604.
TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSE AND SOLUTION
Unit fails to power on.
Unit is not plugged in. Plug power cord into electrical outlet.
Household circuit breaker / ground fault circuit interrupter has tripped or blown fuse. Reset circuit breaker
/ ground fault circuit interrupter, or replace fuse. See IMPORTANT SAFETY INSTRUCTIONS.
Unit has overheated. Automatic Safety Shut Off has initiated. See RESET HEATER.
Internal tip-over switch has been tripped and safety shut-off system has cut power to heater. Place heater
on level surface. See SAFETY FEATURES.
Unit is damaged or in need of repair. Cease usage and unplug. Contact Consumer Service for assistance.
Airflow is diminished.
Check filter and clean as necessary. See CLEANING.
Unit is not producing
Ensure unit is set to High Heat and thermostat is set to highest temperature setting.
sufficient amount of heat.
Close all doors and windows to trap heat.
Allow unit to fully circulate heat throughout room; may take several minutes.
15
English
Publicidad
