Publicidad
Idiomas disponibles
Idiomas disponibles
REMOTE CONTROL
Screwdriver required.
Your VMHi500 heater remote includes (1) coin-style CR2032 battery. Battery comes pre-installed. Remove battery pull tab before first use. The
pre-installed battery has a 1 year life expectancy (dependent on usage) after the tab has been pulled from the remote. The remote is located
inside the EPS Styrofoam surrounding the front and back of the heater. Look for the REMOTE (
the EPS Styrofoam.
1. For battery replacement, the remote
requires one coin-style 3V CR2032 battery.
Always use the correct size and grade of
battery for this product.
2. To replace battery, open battery door
on the back side of the remote control
(you will need to loosen the small screw
on door using a #1 Phillips screwdriver
- screwdriver not included). If necessary,
clean the battery contacts and also those
of the device prior to battery installation.
Remove any plastic protection from the
battery and place it in the remote with the
+ side facing up. Replace the battery door
and screw.
Note: Remove battery from the remote
control when not in use for an extended
period of time and always remove dead
battery immediately and replace with
fresh. Do not store dead battery in remote.
12 English
È
) sticker affixed to the remote polybag inside
3. Your remote control will operate the
MODE
same as the control functions located
on the heater, except when changing
High Heat (1500
modes. When changing modes, both
watts), Low Heat
displays will show either LO, HI or FA
(750 watts) or Fan
on the display as you cycle through.
Only.
Once the selection is made, it will
THERMOSTAT -/+
hold for eight seconds before room
temperature is displayed again.
POWER
The remote requires a line-of-sight path
to allow for the signal to be received
TIMER
by the heater. Position the heater so
the receiver lens (inside the display
on front of heater) is visible from the
CAUTION: DO NOT
remote control.
INGEST BATTERIES.
WARNING: This product contains a button battery. If
swallowed, it could cause severe injury or death in just 2 hours.
Seek medical attention immediately.
CLEANING
Because your heater moves a substantial amount of air, it will need regular cleaning. Cleaning the outside of the heater is recommended
on a weekly basis. If service is required, return your heater to Vornado. See WARRANTY for instructions.
1. Unplug heater before cleaning.
2. Use brush attachment on
household vacuum cleaner to
vacuum any accumulated dust
off Front Outlet Grille.
3. Use brush attachment on
household vacuum cleaner to
vacuum any accumulated dust
off Inlet Filter on back of heater.
4. Wipe down entire heater with a
soft, dry cloth.
You should periodically blow
out the heater with pressurized
air to keep heat element and
motor clear of dust, hair and debris
that can build up inside the heater
as it moves air during use. This also
eliminates unwanted odors caused
by accumulation of these particles
inside the unit.
Note: Inlet Filter on back of heater
is not removable.
Note: Do not modify the product
with any aftermarket accessory.
13
English
Publicidad
