Descargar Imprimir esta página

Broan Elite EI5936SS Manual Del Usuario página 2

Ocultar thumbs Ver también para EI5936SS:

Publicidad

Idiomas disponibles

Idiomas disponibles

Page
2
PLAN THE iNSTALLATiON
iNSTALL THE CEiLiNG SUPPORT
ROOF
CAP
\
6" ROUND
DUCT
///////////////////
DECORATIVE
FLUES
HOOD
\
\
EAVE
VENT
DUCT CENTERLINE
(l"torearofhoodcenterline)
T
I_
HOOD
CENTER
LINE
24" TO 36" ABOVE
COOKING
SUFACE
I
I
The minimum hood distance above cooktop MUST NOT BE
LESS than 24'_
A maximum of 36" above cooktop is recommended
for best
capture of cooking impurities.
Distances
over 36" are at the installer and users discretion;
providing that the ceiling height permits.
Construct wood framing that is flush with interior surface of
the ceiling joists.
NOTE
Hood distance above cooktop is: Minimum 24'; Maximum
36': 9-10 ft. ceilings
may require Flue
Extension
Model
FXNE59SS,
depending
on installation
height
(purchase
separately).
Discard the upper and lower flues, mounting
frame, and trim strips supplied with your hood and replace
them with Flue Extension Model FXNE59SS.
2. Finish opening to match surrounding ceiling carefully marking
framing location.
INSTALL THE WIRING
INSTALL THE DUCTWORK
(Ducted Hoods Only)
1. Decide where the ductwork will run between the hood and
the outside.
2. A straight, short duct run will allow the hood to perform most
efficiently.
3. Long duct runs, elbows
and transitions
will reduce the
performance
of the hood. Use as few of them as possible.
Larger ducting may be required for best performance
with
longer duct runs.
4. Install wall cap or roof cap. Connect round metal ductwork to
cap and work back towards the hood location. Use duct tape
to seal the joints between ductwork sections.
GROUNDING
INSTRUCTIONS
This appliance must be grounded. In the event of an electrical
short circuit, grounding
reduces the risk of electric shock by
providing an escape wire for the electric current.
Position the electrical (house wiring) within the space covered by
the decorative flue and where it will not interfere with the round
duct. Make sure the length of the house wiring is a minimum of 5
feet. It may be shortened after hood is installed at correct height
and electrical connection is made.

Publicidad

loading