Motorola Solutions TLK 25 Serie Manual De Instrucciones página 13

Chapter 3
Mounting the Multi-Unit Charger
A wall mount bracket (Part Number: BR000638A01) is available for the Multi-Unit Charger. Contact your local
dealer to order the item.
WARNING:
● This wall mount bracket must be installed by a trained and experienced technician. Having the
product installed by a nonspecialized technician is very dangerous, and can cause damage or
injury.
● Do not install the product where the weight cannot be supported. If the strength of the location
where the wall mount is installed is not strong enough, it can fall off and cause an injury.
● Do not install the product on a structure that is prone to vibration, movement, or chance of impact
as these conditions might dislodge the devices from the multi-unit charger.
Figure 2: TLK 25 Series Multi-Unit Charger Wall Mount Bracket
Prerequisites:
● Mount the bracket to the wall using the appropriate mounting hardware required for the type of wall
material fixture.
● Motorola Solutions recommends using #6 × 1.5 inches tapping screw and washer (not included) on wood
stud and solid flat concrete or brick wall.
Procedure:
1. Position the wall mount bracket in the desired position.
CAUTION: Ensure that the area behind the mounting surface is always free of electrical wires,
cables, and pipes before cutting, drilling, or installing the mounting screws.
2. Mark the location of the mounting holes on the wall surface.
3. Drill based on the marked mounting holes on the wall surface.
4. To secure the bracket, install the mounting hardware over the mounting holes on the bracket tightly.
MN010237A01-AA
Chapter 3: Mounting the Multi-Unit Charger
13