ION POWER SCAN Guia De Inicio Rapido página 6

CAPTURING IMAGES
1. After you have connected POWER
SCAN to the computer, open the
NimoFilm software.
2. Click "Capture" on the menu bar to
enter into "Photo Preview", then insert
the film holder into the film scanner and
adjust it in right place. When putting in a
film/slide, wait 5-10 seconds to allow
POWER SCAN to adjust to optimal
brightness before scanning.
Note: The film holder cannot be pushed
further back.
3. Select the location of the folder to save
the image before you capture. By
default NimoScan will save in "My
Documents\My
change the location if you wish.
4. Click the "Capture" button in the
software or the 'SCAN' button on
POWER SCAN to capture the image. It
will take several seconds to save the
image that you have captured.
Film Types: There are three film types that you can choose from: Positive, Negative and Black-White.
The default film type mode is Negative.
Resolution: There are two kinds of photo resolutions that you can choose from when scanning: 900dpi
and 1800dpi.
Color Adjust: There are 3 Preset modes to select from which will automatically adjust the image
settings (Nature, Colorful, Old Photo) or you can select Customize mode which will allow you to adjust
the Saturation, Brightness, Contrast, or Color Balance. If you want to change the settings, adjust the
cursor to a point where the image looks best.
Pictures". You can
6