Publicidad
Idiomas disponibles
Idiomas disponibles
Care for your battery charger
Every day
Check that your battery charger is clean. If you
notice any dust or dirt:
Unplug the power adaptor and remove any
1
battery modules.
2
Hold the battery charger upside down and tap
it gently to remove any dirt from the battery
charger sockets. Carefully blowing on the
battery charger sockets may also help remove
dirt.
Wipe the battery charger sockets with a soft
3
dry cloth.
Cycle batteries in different sockets when
recharging to wear the sockets evenly.
If it gets wet
If the battery charger ever gets splashed with
liquid, carefully shake out the liquid and dry the
battery charger for 24 hours. Do not use the
battery charger until it is dry.
Using Share the Experience
See figure
12
Family members and friends can "share the
experience" of bone conduction hearing. The test
rod can be used by others to hear with the sound
processor.
To use the test rod
1
Turn on your sound processor and snap the
Actuator unit onto the test rod using the tilt
technique.
Place the Sound Processing unit on the ear.
2
Hold the rod against the skull bone behind an
ear. Plug both ears and listen.
Wear an Earhook+ or Earhook 2+
The Earhook+ or Earhook 2+ is used when wearing
the sound processor in the under-the-ear (UTE)
position. Both are available in different sizes.
Earhook+ is available in different colours and
Earhook 2+ is transparent.
10
Attach an Earhook+
1
Press firmly on the top of the Earhook with
your thumb to click it off the sound processor.
2
Click the Earhook+ into place.
Attach and adjust the silicone band to ensure
3
the Earhook+ sits securely.
Carefully bend the upper part into shape to suit
4
your ear.
Remove an Earhook+
Remove your Earhook+ by clicking it off the
processor and removing the silicone band.
Attach an Earhook 2+
Press firmly on the top of the Earhook with
1
your thumb to click it off the sound processor.
Slide the Earhook 2+ into place.
2
Make sure that your sound processor is
3
thoroughly seated within the Earhook 2+.
Remove an Earhook 2+
Remove your Earhook 2+ by sliding the sound
processor out of the Earhook 2+.
Wear a Snugfit
The Snugfit holds your sound processor more
securely in place than an earhook alone. It gives
carers easy access to controls and accessories and
is available in large, medium and tamper resistant
(small).
Attach a Snugfit
See figure
1
Press firmly on the top of the earhook with
your thumb to click it off the sound processor.
2
Click your Snugfit into place.
3
Carefully bend the lower part into shape to suit
your ear.
Remove a Snugfit
4
Remove your Snugfit by clicking it off the
processor.
See figure
13
See figure
14
15
Publicidad
