Publicidad
LDAC
3
3. Select "Preferred audio quality" to switch to LDAC codec.
4. You will be notified that the earbuds do not support LDAC when
connected to two devices. Select "Turn on" to continue.
5. It takes about 10 seconds to switch audio codecs. You may be
asked to update the earbuds' firmware if available.
POWERING OFF
To power off, return the earbuds to the charging case and close it. The
earbuds will automatically power off after 30 minutes if they are not
connected. The duration can be set in the soundcore app.
LED LIGHT GUIDE
LED
Description
Short light breathing red
Short light breathing white
Long light breathing white
Long light steady white for 5 minutes 100%
4
5
2
1
Battery level
during charging
20%
<
20% - 60%
60% - 99%
WEARING DETECTION
L/R
L R
Playback will automatically pause when an earbud is removed
and will resume again once you wear it. Wear either earbud to
automatically answer an incoming call.
RESET
Reset if the earbuds have issues pairing with each other or with other
devices. Delete the pairing history from your Bluetooth device first.
Place the earbuds in the charging case and leave the case open.
Press and hold the charging case button for 10 seconds until the LED
indicators flash white rapidly three times.
LED
Short light steady red for 5
seconds, and then off
Short light steady white for 5
seconds, and then off
Long light steady white for 5
seconds, and then off
EN 03
L/R
1
×3
2
10s
Description
Battery level
<
20% - 60%
60% - 100%
20%
Publicidad
