Accessories; Standard Accessories - Hitachi Koki G 10SR3 Manual De Instrucciones

8. Service parts list
A: Item No.
B: Code No.
C: No. Used
D: Remarks
CAUTION
●
Repair, modification and inspection of Hitachi
Power Tools must be carried out by a Hitachi
Authorized Service Center.
This Parts List will be helpful if presented with the
tool to the Hitachi Authorized Service Center when
requesting repair or other maintenance.
In the operation and maintenance of power tools,
the safety regulations and standards prescribed
in each country must be observed.
WARNING
Never use any accessories other than those mentioned below.
The use of any accessories other than those mentionded below or attachments not intended for use such as
cup wheel, cut-off wheel or saw blade is dangerous and may cause personal injury or property damage.
NOTE
Accessories are subject to change without any obligation on the part of the HITACHI.

STANDARD ACCESSORIES

(1) For grinder supplied with Carrying Case
Wrench .................................................................. 1
(Code No. 936522 ............................... G10SR3)
(Code No. 938332Z ............................. G12SR3)
Side Handle (Code No. 318312) ........................... 1
Depressed center wheel ....................................... 1
4" (100mm) external dia. × 1/4" (6mm) thickness ×
5/8" (16mm) hole dia.
(Code No. 701040 or 326204) ............. G10SR3
4-1/2" (115mm) external dia. × 1/4" (6mm)
thickness × 7/8" (22mm) hole dia.
(Code No. 701045 or 326203) ............. G12SR3
(2) For grinder supplied without Carrying Case
Wrench .................................................................. 1
(Code No. 936522 ............................... G10SR3)
(Code No. 938332Z ............................. G12SR3)
Side Handle (Code No. 318312) ........................... 1
Depressed center wheel ....................................... 1
4" (100mm) external dia. × 1/4" (6mm) thickness ×
5/8" (16mm) hole dia.
(Code No. 701040 or 326204) ............. G10SR3
4-1/2" (115mm) external dia. × 1/4" (6mm)
thickness × 7/8" (22mm) hole dia.
(Code No. 701045 or 326203) ............. G12SR3
NOTE
Specifications are subject to change without any
obligation on the part of the HITACHI.
MODIFICATIONS
Hitachi Power Tools are constantly being improved
and modified to incorporate the latest
technological advancements.
Accordingly, some parts (i.e. code numbers and/
or design) may be changed without prior notice.

ACCESSORIES

English
13