Vortice NORDIK ECO Manual De Instrucciones página 7

Operation
Max power: 5,38 mW
Operating frequency: 2412 ÷ 2472 Mhz
Caution!!! The information described in this chapter
only relates to use of the VORTICE Code 12829
POT-R regulator (to be purchased separately)
Operation is possible with other potentiometers provi-
ded they have the following characteristics:
1 - Resistive value 10kOhm
2 - Integrated or external switch (fig.57)
Fans are turned on by means of a switch integrated
into the potentiometer. Start from the stand-by posi-
tion on the knob and turn it clockwise. You will hear a
click when the switch closes and then, when the fan is
switched back on, you will hear a brief buzzer tone
accompanied by a quick ignition of the LED.
The speed setting is continuous. The first half of the
potentiometer full scale is dedicated to adjusting pro-
duct speed in "standard" ventilation (air pushed
toward the floor). The second half of the full scale is
dedicated to "reverse" mode adjustment (air pushed
toward the ceiling). Fan passage from "standard" ven-
tilation to "reverse" ventilation is highlighted by two
short buzzer tones and two quick ignitions of the LED,
while passage from "reverse" ventilation to "standard"
ventilation is highlighted by a brief buzzer tone and a
quick ignition of the LED (fig.51).
A transition zone (HYSTERESYS ZONE) is indicated
on the potentiometer (fig.52), corresponding to passa-
ge from "standard" ventilation mode operation (at
maximum speed) to "reverse" ventilation mode opera-
tion (minimum speed).
Shut-down occurs by completely rotating the knob in
the counter-clockwise direction. A long buzzer tone
and a long LED ignition will indicate shut-down.
Some optional accessories, even in combination with
each other, make it possible to use the device. The
possible combinations are:
• Potentiometer POT-R cod.12829 (or other)
• Remote controller Telenordik Eco cod.21200
• Potentiometer + Remote controller
• Remote Controller Unit Vort Delta T Wifi cod. 21175
• Remote Controller Unit RH T Wifi MODBUS cod.
20316 (only mod. 120)
Caution
Switch off the potentiometer if present to use the
"TELENORDIK ECO".
Caution
The RH T Wifi MODBUS accessory is about to be
launched and may not be available yet.
Cleaning
Figures: 53 ÷ 56.
Before performing any cleaning or maintenance ope-
rations, turn the unit switch off and disconnect its plug
from the power supply.
Electrical connections
Figures: 57 ÷ 58
Dismantling caps
Figures: 59 ÷ 62 (rods 290÷915)
Figures: 63 ÷ 68 (rod 160)
Declaration of conformity UE
The company Vortice S.p.A. declares that the
Nordik Eco appliance complies with the 2014/53 /
EU directive.
The full text of the EU declaration is available at
the following Internet address:
(see: Certificazioni, CE)
http://www.vortice.it/it/ventilazione-
estiva/soffitto/residenziale/61061
ENGLISH
7